Operation Manual

16
14.2 Empty grounds container
Coffee grounds are collected in the grounds container.
 EMPTY GROUNDS
 If this message shows on the display no more coffee can be
drawn off. It is necessary to empty the grounds container.
 Remove drip tray carefully as there is water in it.
Do not disconnect the machine from power socket while
you empty grounds.
14.3 Empty drip tray
 EMPTY TRAY
 If this message shows on the display no more coffee can be
drawn off. It is necessary to empty the drip tray.
 Remove drip tray carefully as there is water in it.
14.4 Fill beans
 FILL BEANS
 Fill in beans as described in chapter 3.3.
The message FILL BEANS will only disappear after drawing
off a coffee. We recommend cleaning the bean container
from time to time with a dry cloth before you refill beans.
Switch off the machine for this purpose.
14.5 Removing foreign objects
 Switch off your machine by pressing ON/OFF key.
 Remove plug from power socket.
 Open bean container (13) and remove the beans. The remaining
beans can be removed with a vacuum cleaner.
16
 Loosen both screws in the bean container and then remove con-
tainer (Fig. 5+6)
 Remove any remaining beans with a vacuum cleaner.
 Put the spanner on (Fig. 7).
 Now turn spanner anticlockwise until the foreign object loosens.
 Remove remaining powder with a vacuum cleaner.
 Replace bean container and fasten screws.
14.6 Clean machine
 CLEAN UNIT
After coffee, etc., has been drawn off 220 times or after 180 rinsing
programs have been run, the machine must be cleaned. You can
continue to draw off coffee and hot water / steam. However we re-
commend that you clean the machine (as described in chapter 14)
within the next few days.
 CLEAN NOW
An acoustic signal indicates the need of an immediate cleaning.
14.7 Unit calcified
 UNIT CALCED
The machine signals when decalcifying becomes necessary.
Under the correct implementation of CLARIS plus filter car-
tridges, decalcifying of the machine becomes unnecessary.
For further indications read Chapter 7 “Use of CLARIS plus
filter cartridges”.
14.8 Cleaning metal contacts
 EMPTY TRAY
To switch off this message you need to remove calcified deposits
from the metal contacts. Proceed as follows: