LD 5000 REFERIGERANT LEAK DETECTOR JB INDUSTRIES INC.
PRODUCT OVERVIEW JB Industries is proud to unveil the new, revolutionary LD 5000 PROWLER refrigerant gas leak detector. Using our new proprietary JBI Electrochemical sensor technology for unparalleled accuracy coupled with the unique user features, there simply is no better hand held probe type service leak detector system on the market.
NEED A PICTURE of Control Panel POWER ON/OFF SENSITIVITY LEVEL MUTE BUTTON BACKLIGHT BUTTON HOW TO OPERATE 1) TURN ON: Press the ON/OFF button once to turn on and again to turn off. NOTE: Hold button down for approximately 1 second to turn unit off. 2) WARM UP: The detector automatically energizes the sensor conditioning it for use. During the sensor conditioning cycle, the digital graph leak size indicator wil gradually increase and the detector will sound a slow “beep”.
MED LEAK SIZE INDICATOR The digital leak size indicating LCD graph display remains off normally but once a leak is detected, a number of indicating bars (up to 10 bars with increasing height) will be displayed for all HFC and HCFC refrigerants regardless of the sensitivity setting. NOTE: The LCD display angle can be adjusted for ease of viewing when referring to the display for leak size. The display may be adjusted from normal viewing (closed position) to a 30 degree angle if required.
BACKLIGHT To turn on the LCD display backlight, press the Backlight button once. Press again to turn off. LEAK TEST VIAL The PROWLER comes with a Leak Test Vial that allows the user to make sure the detector is performing properly. To test: 1) Remove the plastic seal label on top of the Leak Test Vial by pulling it off (see fig. below). 2) Turn on the detector and allow the unit to complete the warm up mode (Sensitivity level set at MED).
Sensor: Replace Filter: Unscrew sensor tip as shown to replace filter. Replace filter whenever it becomes visibly dirty or every 2 to 3 months depending on use. Replace Sensor: Remove sensor by pulling out of socket. Install the new sensor by aligning the notch in sensor cover with the raised keyway on the sensor socket holder.(see figure below) Note: Do not force sensor into socket. Misalignment can damage the sensor pins.
PROWLER SPECIFICATIONS Model #: Name: Sensitivity: Sensor Life: Response Time: Power Supply: Battery Life: Warm Up Time: Probe Length: LCD Display: Weight, lbs.: Warranty: LD 5000 PROWLER Leak Detector, Refrigerant Gas 0.025 oz/yr R-22, 0.05 oz/yr R-134a, 0.0125 oz/yr R-1234yf, 0.05 oz/yr R-410A, 0.05 oz/yr R-404A, 0.05 oz/yr R-407A, 0.05 oz/yr R-427A > 10 years (normal use) Instantaneous 4 AA Alkaline batteries 4.5 hours continuous < 20 seconds 17” Sensitivity, Battery Light, Leak Level Indication 1lb.
REPLACEMENT PARTS Description Part Number Replacement Sensor with filter Replacement Filters (5 pack) Leak Test Vial Parts Kit (sensor, filter kit, test vial) Carrying case LD-S101 LD-RF5 LD-TV LD-PK LD-CS WARRANTY The PROWLER LD 5000 Refrigerant Gas Leak Detector is warranted to be free of defects in materials and workmanship for a period of two years from the date of purchase.