User's Manual
EN
Plug in the power cord, press the ‘Spray’ button
and ‘Nozzle Clean’ button on the right side of
the product at the same time and hold them for
more than 2 seconds. The buzzer sounds, and
the LED blinks. You will enter the communication
connection (pairing) setting mode.
Within 15 seconds after entering the
communication connection (pairing) setting
mode, press and hold the ‘Spray’ button on the
remote controller for more than 5 seconds to
proceed with pairing of the remote controller and
the main body’s controller.
After pairing is completed, the remote
controller’s LED (wide, water/Air temperature,
seat temperature) blinks three times in orange,
indicating that the pairing is nished.
(But, paired operation is possible at least 15
seconds after start of the setting.)
How to pair the main body with the remote controller
Pairing involves connecting the remote controller to the controller receiver of the main body. You can perform
pairing of the main body and remote controller in the following order and use your remote controller afterward.
How to set the remote controller connection (pairing)
15