User's Manual

Installation
Install product


Place the fixing slider over the installation plate
on the toilet, insert the fixing bolts, and fasten
the nuts so that the installation plate is fixed.
Align the back of the bidet to the installation
plate and push the bidet backwards. Hold the
bidet with both hands and push it backwards
until it clicks into place. To adjust the installation
plate, loosen anchor nuts underneath the toilet
and slide the bidet forward or backwards for the
right position. After that, tighten anchor nuts to
hold in place.
󾖴󾖴
Check if the bidet moves to the left or right. If it moves,
fasten the fixing nuts again.
󾖻
󾖻
Please connect the T-shaped connectors
to the water supply pipe first. If the water
supply pipe does not fit or the pipe type is
rigid, the 7/8" T-shaped connector can be
connected to the inlet of the toilet tank.








If your T-shaped connector is not fit to your
bathroom water pipe because its size is 1/2",
please use 1/2" conversion bolt and nut
after connecting them to the 3/8" T-shaped
connector.
Conversion nut
(with packing)
T-shaped connector
(with packing)
Conversion bolt
(with packing)
Toilet tank
T-shaped
connector
Rubber
packing
Cold water
supply line
30
03 MAINTENANCE