User's Manual

H. Notice.
c) If the investigation indicates acompliance concern the host product
manufacture is obligated to mitigate the issue. Host products using a
modular transmitter are subject to all the applicable individual technical
rules as well as to the general conditions of operation in Sections
15.5,15.15,and 15.29 to not cause interference. The operator of the host
product will be obligated to stop operating the device until the
interference has been corrected.
Below are steps for on test mode:
CN2
1 2 3 4
Pin # NAME
1 VCC(+3.3V)
2 Serial interface
3 Pairing
4 GND
This board is controlled by Control board via SPI.
The MCU(S3F94C4) controls GFSK board and send data received from
GFSK board to the BIDET.
This board is pairing to Remote Control when received pairing signal
from BIDET via <PAIRING>pin on CN2.