User's Manual

12 OPERATOR CONVENIENCES

These keys and controls are available on the

Commander to control the Transporter.

Note:

◆

You cannot recall memory channels 100 to 299 using [ENT] and

the numeric keys.

To recall memory channels 100 ~ 299, use [+]

or [–].

◆

You can recall only the memory channels that have HF/ 50 MHz

frequencies.

USING A SEPARATE TRANSPORTER

If you have more than 2 TH-D7A and/or TM-D700A

transceivers, you can use one of the transceivers as

a “Transporter”. This transceiver is connected to the

TS-2000(X) via the RS-232C port, EXT SP jack, and

Mic connector of the base station and the other

TH-D7A or TM-D700A transceiver works as a

“Commander”. With this configuration, you can turn

the TS-2000(X) ON and OFF using the

“Commander”. Refer to the instruction manual of the

TH-D7A or TM-D700A for interfacing the transceiver

to the TS-2000 transceiver.

TS-2000 + TH-D7A/ TM-D700A (Transporter) Setup:

1 Configure the TH-D7A or TM-D700A as a

“Transporter” and connect all the necessary

cables to the TS-2000.

2 Select a frequency (HF/ 50 MHz band) on the

main transceiver of the TS-2000.

3 On the TS-2000 Press [MENU], then turn the

MULTI/ CH control to access Menu No. 62E.

4 Select a “CLIENT”.

5 Press [MENU] to complete.

6 Start the Transporter mode on the TH-D7A or

TM-D700A.

TH-D7A/ TM-D700A (Commander) Setup:

Configure the TH-D7A or TM-D700A as a

“Commander”. Refer to the SKY COMMAND II

chapter in the instruction manual to set up the

transceiver as a “Commander”.

You can use a “Commander” as described on pages

84 and 86.