User's Manual

5
1 INSTALLATION
PORTABLE BRACKET (E-TYPE ONLY)
Using the supplied Portable Bracket, you can carry the Remote Control panel and TX/ RX unit together.
Two TX/ RX unit positions are available. If you do not use the EXT.SP, REMOTE or DATA terminals, place the
transceiver in front position. If you use the EXT.SP, REMOTE or DATA terminals, place the TX/ RX unit to the
back position. You can also attach the handle as shown if necessary. Use the supplied short cable (RJ11/ 20 cm)
to connect the Remote Control panel and the TX/ RX unit.
FUSES
The following fuses are used in the TS-480SAT/ HX transceiver. If a fuse blows, determine the cause then correct
the problem. Only after the problem has been resolved, replace the blown fuse with a new one with the specified
ratings. If newly installed fuses continue to blow, disconnect the power plug and contact a KENWOOD service
center or your dealer for assistance.
noitacoLesuF gnitaRtnerruCesuF
XH/TAS084-ST
)tinuXR/XT(
A4
)renutannetnalanretxenaroF(
rewopCDdeilppuS
elbac
A52
SEMS screw
(M4 x 10 mm)
SEMS screw
(M4 x 10 mm)
DC
13.8V
1
DC 2 13.8V
AT
GNDGND
22
1
Binding head screw
(M4 x 8 mm)
Flat-head screw
(M4 x 12 mm)
RJ11/ 20 cm
Carrying handle
PANEL
MIC
PADDLE
KEY
EXT.SP DATA REMOTE
COM
PANEL
MIC
PADDLE
KEY
EXT.SP DATA REMOTE
COM
1 Remove 7 screws at the bottom of the TX/ RX unit.
2 Remove 8 screws inside of the TX/ RX unit.
3 Lift the shield cover.
4 Replace 4 A fuse.