Manual

Initial Setup
Channel Summary. Lock
&V to CHANNEL SUMMARY
• • To operate
_i,V To the Lock Column
(_) Zero to lock or unlock that channel
01 X -
02 X -
03 X -
04 X -
05 X -
=o It
O6 X
07 - :
: 08 -
: og x
: lO x
(_ Exit when finished
Channel Guard Message
When a viewer attempts to watch a guarded channel,
the following message appears:
THISCHANN ,ocK OBY
CHAN_L GUARO_
ENIFRU CR
lo PAn,TO
NO. - . . .
To watch a channel that you have locked, enter the
Lock Code using the 10 key pad (see "Set Lock
Code" - at the top of the next column).
If the wrong code is entered, this message will flash
on the screen:
I INVALID LOCKCODE! I
Set Lock Code
(V-Chip, which appears before Set Lock Code in
the onscreen menu system, is discussed in the
four-page section beginning on page 15).
Channel-Guard and V-Chip settings are protected
by a four-digit Lock Code. Your TV comes pre-set
with a Lock Code of "0000". You may change the
code to any four-digit number you wish. To
change the Lock Code, follow the steps below.
t_ Press the MENUbutton
&V To SET LOCK CODE
• • To operate
It
The padlock icon appears
_) Press ZEROto access the Lock Code
I LOCKCODE FINISH 0000 I
The first digit will be highlighted
• • To select the number
&V To move to the next digit
Continue to follow these directions for all four
numbers
&V To FINISH
• • To save your settings and exit
THANKYOUI!
The channel cannot be accessed until the correct
code is entered.
• Once a channel has been unlocked, it will
remain unlocked until the television is turned off.
NOTES:
After a power interruption you must reset the Lock Code.
Writeyour Lock Code number down and keep it hidden from potential viewers.
If you forget the Lock Code, a new code may be set using the steps listed above.