Manual

Connections
Connecting to JVC AV Compu Link Capable Components
JVC's AV Compu Link feature makes playing video tapes totally automatic. Simply insert a pre-recorded tape*
into your JVC-brand VCR and the VCR will automatically turn on and begin playback. At the same time, using
the AV Compu Link, the VCR sends a signal to the television telling it to turn on and switch to the proper video
input to watch a video tape.
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you wish to connect.
If it is not, contact an authorized JVC Service Center for part # EWP 805-012.
• AV Compu Link can only be used with JVC-brand products.
Illustration of AV-32D501
VCR
AV
Compu
Link EX
Swap
To Connect: Plug one end of the AV Compu Link cable into the AV Compu Link input on your VCR or other Compu
Link device. Plug the other end of the AV Compu Link cable into the AV Compu Link input at the rear of the television.
Connecting to a Camcorder
I You may connect a camcorder to your television by using the front Input Jacks (Input 3) located under the front
panel door. To access, press lightly on the door to open it. You may also connect a game console or other
equipment using these jacks. Camcorders may also be connected to the television's rear input jacks.
CAMCORDER
!) Connect the yellow video cable out from the Camcorder's Video Output, in to the TV's Video Input jack.
2) Connect the white audio cable out from the Camcorder's Left Audio Output, in to the TV's Left Audio Input Jack.
3) Connect the red audio cable out from the Camcorder's Right Audio Output, in to the TV's Right Audio Input jack.
• If your Camcorder is a mono sound model it will have only one audio jack. Connect to the TV's Left Audio Jack.
NOTES (For AM Compu Link):
* In order for the VCRplayback to begin automatically,the recording tabs must be removedfromthe VHStape. If the tab is in place,
automaticswitching will occur when you push the VCR'sPLAYbutton.
• TheAVCompu Link cable has a male 3.5 mm (mono)plug on eachend.
• If your JVC-brand VCRhas "A Code/B Code Remote ControlSwitching"(see your VCR'sinstructionbook),using VCRA Code will
switch the TVtoinput 1.ff you use Input 1for video input fromyour cable box, use VCRB Code to select the TV VideoInput2.
• Toconnect a JVCHiFireceiveror amplifier for a completelyautomated home theater,seethe HiFi'sconnectioninstructionsfor detailed
connectioninformation
• AVCOMPULINK EXis compatible withthe followingreceivers:RX4_64V,RX4_65V,RX-668VBK,RX-774V,RX-778VBK,RX-884V,
RX-888VBK,RX-1024V,RX-I028VBK,and later receivermodels.