Operation Manual

19
Advanced Radio Operations
Remote control
Receiving FM Stations with Radio
Data System
Remote
ONLY
Radio Data System allows FM stations to send an additional
signal along with their regular program signals.
This System can receive the following types of Radio Data
System signals.
PS (Program
Service)
Shows commonly known station
names.
PTY (Program
Type)
Shows types of broadcast programs.
RT (Radio Text)
Shows text messages the station
sends.
Enhanced Other
Networks
Provides information about the
types of the programs broadcast by
the Radio Data System stations of
the different networks.
To show the Radio Data System information
While listening to an FM station...
PS
Station names are displayed. “NO PS” will appear
if no signal is sent.
PTY
The broadcast program type is displayed.
“NO PTY” will appear if no signal is sent.
RT
Text messages the station sends are displayed.
“NO RT” will appear if no signal is sent.
Searching for a Program by PTY
Codes
Remote
ONLY
You can locate a particular kind of program from the preset
channels (see page 9) by specifying the PTY codes.
To search for a program using the PTY codes
1 While listening to an FM station...
2 Select a PTY code (see page 20).
3 Start searching.
The System searches for 30 preset FM stations, stops
when it finds the one you have selected, and tunes in to
that station.
• If no program is found, “NOTFOUND” appears on
the display.
• To stop searching any time during search, press
PTY SEARCH.
To continue searching after it stops on an unwanted station
While the indications on the display are flashing, press
PTY SEARCH again.
Ex.: When “NEWS” is selected
Frequency
(Non-Radio Data System signal)
EN_UX-G950V[B]5.indb 19EN_UX-G950V[B]5.indb 19 08.4.18 5:32:17 PM08.4.18 5:32:17 PM