Super Projector Instructions

17
ENGLISH
Installing the Projector
Precautions for Installation
■ When installing the projector, observe the following:
• Do not use the projector placed on its side or upside down.
The projector cannot be used by being placed on its side or upside down; otherwise, it could malfunction.
• Use the projector within the range of allowable installation angle.
Avoid using the projector inclined over 5° right-to-left or left-to-right, over 25° front-to-rear or rear-to-front; otherwise it could
cause color variation or harm the lamp life.
• Do not block the exhaust vents.
Do not use a cover which encloses the projector intake or blocks the exhaust vents. Allow sufficient space around the
projector. When the projector is enclosed in a space of the following dimensions, use an air conditioner so the temperature
inside becomes equal to the outside temperature.
Allowable minimum space required
CAUTIONS
• Since the projector weighs approx. 92 kg (203 lbs.), be sure to have four or more people when
lifting or moving it; otherwise, the projector could possibly drop, causing personal injury and/or
damage to the projector.
• Do not install the projector in the following places:
• There is much water, humidity or dust.
• The projector may be subjected to oil smoke or cigarette smoke.
• On a soft surface such as a carpet or cushion.
• The projector may be subjected to direct sunlight.
• Temperature is high or humidity is low.
Allowable operation temperature range: + 5°C to + 35°C (41°F to 95°F)
Allowable relative humidity range: 20% to 80% (no condensation)
Allowable storage temperature range: –10°C to +60°C (14°F to 140°F)
305 mm (12”)
600 mm (23-
5
/8”)
600 mm (23-
5
/8”)
305 mm (12”)
600 mm (23-
5
/8”)
ZOOM
FOCUS
T
W
MENU
ENTER
EXIT
VIC SELECT
1
2
3
KEY STONE
OPERATE
HIDE
STAND BY
REMOTE
CONTROL
RS-232C OUT
RS-232C IN
R
G
B
Y
H/C
S
RGB Analog VIC
Front view
Right side view
EN17-31QX1G_f.pm6 02.3.7, 13:3717