Owner's Manual
Table Of Contents
- Instructions
- Getting Started
- Set up
- Operate
- Adjust/Set
- Maintenance
- Troubleshooting
- Others
- Quick Start Guide
- External Command Communication Specification
- 1 Outline
- 2 Interface
- 3 Protocol
- 4 Command control
- 4.1 NULL command
- 4.2 Power [PoWer]
- 4.3 Input [InPut]
- 4.4 Remote control pass-through [RemoteCode]
- 4.5 Setup [SetUp]
- 4.6 Gamma data of Gamma table “Custom 1/2/3” [GammaRed, Green, Blue]
- 4.7 Panel Alignment (zone) Data [Panel Alignment(Zone) Red, Blue]
- 4.8 Source Asking [SourCe]
- 4.9 Model status asking [MoDel]
- 4.10 Adjustment [AdjustmentCommand]
- Command code
- Parameter1
- Parameter2
- 4.10.1 Special data
- Special data
- Picture mode
- Color Profile
- Color Temp. Table Data
- Color Temp. Correction Data
- Gamma Table Data
- Gamma Correction Data
- Dynamic Control Data
- Color Management Data
- Low Latency Data
- Clear Motion Drive Data
- Motion Enhance Data
- LD Power Data
- Graphic Mode Data
- HDMI Input Level Data
- HDMI Color Space Data
- HDMI 2D/3D Data
- Aspect Data
- Mask Data
- Lens Control(Focus Near, Focus Far, Zoom Tele, Zoom Wide, Shift Left, Shift Right, Shift Up, Shift Down) Data
- Lens Image Pattern, Lens Lock, Screen Adjust, Uniformity Correction Data
- Installation Style Data
- Anamorphic Data
- Panel Alignment Switch Data
- High Altitude mode
- Back Color Data
- Menu Position Data
- Source Display
- Language Data
- Trigger Data
- Off Timer Data
- Eco Mode Data
- Control 4 Data
- Input Data
- Source Data
- Deep Color Data
- Color Space Data
- Colorimetry Data
- HDR Data
- 4.10.2 Special2 Data
- 4.10.3 Special3 Data
- 4.10.4 Special9 Data
- 4.10.5 Special10 Data
- 4.10.6 Special14 Data
- 4.10.7 Operation
- 4.10.8 Reference
- LAN setup [Lan Setup]
- Screen Codes
- Safety Precautions
4 Command control
17 / 45 PJ05030305B
4.5 Setup [SetUp]
Used to change the initial setting.
Command code
Table 4-9 SETUP CMD
HEX
ASCII
Function
0x53
0X55R
'S'
'U'
Initial setting [SetUp]
Parameters
Data length: No regulation
Sub command table (Mandatory command only)
Table 4-10 SETUP CMD SUB
HEX
ASCII
Function
Last
Memory
Operation
Reference
0x52 0x53
'R' 'S'
Switch the external control
command protocol
No
-
0x52
0x43
‘R’
‘C’
Switch the IR code
No
It consists of “Sub command” + “Setting”. The Sub command consists of ASCII character two bytes.
Sub commands parameters are as follow.
Parameters when the Sub command is [0x52,0x53] : Data length 1
HEX
ASCII
Operation
0x31
‘1’
Compatible command system
Parameters when the Sub command is [0x52,0x43] : Data length 1
HEX
ASCII
Operation
0x30
‘0’
A code(0x73)
0x31
‘1’
B code(0x63)