Owner's Manual
Table Of Contents
- Instructions
- Getting Started
- Set up
- Operate
- Adjust/Set
- Maintenance
- Troubleshooting
- Others
- Quick Start Guide
- External Command Communication Specification
- 1 Outline
- 2 Interface
- 3 Protocol
- 4 Command control
- 4.1 NULL command
- 4.2 Power [PoWer]
- 4.3 Input [InPut]
- 4.4 Remote control pass-through [RemoteCode]
- 4.5 Setup [SetUp]
- 4.6 Gamma data of Gamma table “Custom 1/2/3” [GammaRed, Green, Blue]
- 4.7 Panel Alignment (zone) Data [Panel Alignment(Zone) Red, Blue]
- 4.8 Source Asking [SourCe]
- 4.9 Model status asking [MoDel]
- 4.10 Adjustment [AdjustmentCommand]
- Command code
- Parameter1
- Parameter2
- 4.10.1 Special data
- Special data
- Picture mode
- Color Profile
- Color Temp. Table Data
- Color Temp. Correction Data
- Gamma Table Data
- Gamma Correction Data
- Dynamic Control Data
- Color Management Data
- Low Latency Data
- Clear Motion Drive Data
- Motion Enhance Data
- LD Power Data
- Graphic Mode Data
- HDMI Input Level Data
- HDMI Color Space Data
- HDMI 2D/3D Data
- Aspect Data
- Mask Data
- Lens Control(Focus Near, Focus Far, Zoom Tele, Zoom Wide, Shift Left, Shift Right, Shift Up, Shift Down) Data
- Lens Image Pattern, Lens Lock, Screen Adjust, Uniformity Correction Data
- Installation Style Data
- Anamorphic Data
- Panel Alignment Switch Data
- High Altitude mode
- Back Color Data
- Menu Position Data
- Source Display
- Language Data
- Trigger Data
- Off Timer Data
- Eco Mode Data
- Control 4 Data
- Input Data
- Source Data
- Deep Color Data
- Color Space Data
- Colorimetry Data
- HDR Data
- 4.10.2 Special2 Data
- 4.10.3 Special3 Data
- 4.10.4 Special9 Data
- 4.10.5 Special10 Data
- 4.10.6 Special14 Data
- 4.10.7 Operation
- 4.10.8 Reference
- LAN setup [Lan Setup]
- Screen Codes
- Safety Precautions
4 Command control
25 / 45 PJ05030305B
4.10 Adjustment [AdjustmentCommand]
Used for adjusting some function.
Command code
Table 4-17 ADJUSTMENT CMD
HEX
ASCII
Function
0x50
0x4D
'P'
'M'
Picture Adjust
0x49
0x53
‘I’
‘S’
Input Signal
0x49
0x4E
‘I’
‘N’
Installation
0x44
0x53
‘D’
‘S’
Display Setup
0x46
0X55R
‘F’
‘U’
Function
0x49
0x46
I'
‘F’
Information
Parameter1
Parameter1: Sub command
Data length: ASCII character 2 bytes
Parameter1 table is as follow.
Table 4-18 ADJUSTMENT CMD SUB
Command
Code
Parameter1
Function
Operation
Reference
Data type
'P'
'M'
‘P’
‘M’
Picture Mode switch
Special 4
'P'
'M'
‘P’
‘R’
Color Profile switch (*1)
Special
'P'
'M'
‘C’
‘L’
Color Temperature table switch
Special
'P'
'M'
‘C’
‘C’
Color Temperature Correction switch
Special
'P'
'M'
‘G’
‘R’
Color Temperature Gain (Red) adjustment
Numeric
'P'
'M'
‘G’
‘G’
Color Temperature Gain (Green) adjustment
Numeric
'P'
'M'
‘G’
‘B’
Color Temperature Gain (Blue) adjustment
Numeric
'P'
'M'
‘O’
‘R’
Color Temperature Offset (Red) adjustment
Numeric
'P'
'M'
‘O’
‘G’
Color Temperature Offset (Green) adjustment
Numeric
'P'
'M'
‘O’
‘B’
Color Temperature Offset (Blue) adjustment
Numeric
'P'
'M'
‘G’
‘T’
Gamma Table switch
Special
'P'
'M'
‘F’
‘W’
Picture Tone (White) adjustment
Numeric
'P'
'M'
‘F’
‘R’
Picture Tone (Red) adjustment
Numeric
'P'
'M'
‘F’
‘G’
Picture Tone (Green) adjustment
Numeric
'P'
'M'
‘F’
‘B’
Picture Tone (Blue) adjustment
Numeric
'P'
'M'
‘C’
‘N’
Contrast adjustment
Numeric
'P'
'M'
‘B’
‘R’
Brightness adjustment
Numeric
'P'
'M'
‘C’
‘O’
Color adjustment
Numeric
'P'
'M'
‘T’
‘I’
Tint adjustment
Numeric
'P'
'M'
‘D’
‘C’
Dynamic Control
Special
'P'
'M'
‘R’
‘N’
NR adjustment
Numeric
'P'
'M'
‘G’
‘C’
Gamma Correction switch
Special 4
'P'
'M'
'D'
'R'
Gamma Red data
Special 2
'P'
'M'
'D'
'G'
Gamma Green data
Special 2
'P'
'M'
'D'
'B'
Gamma Blue data
Special 2
'P'
'M'
‘R’
‘W’
Bright Level White
Numeric
'P'
'M'
‘R’
‘R’
Bright Level Red
Numeric
'P'
'M'
‘R’
‘G
Dark Level Green
Numeric
'P'
'M'
‘R’
‘B’
Dark Level Blue
Numeric
'P'
'M'
‘K’
‘W’
Dark Level White
Numeric
'P'
'M'
‘K’
‘R’
Dark Level Red
Numeric
'P'
'M'
‘K’
‘G
Dark Level Green
Numeric