Owner's Manual
Table Of Contents
- Instructions
- Getting Started
- Set up
- Operate
- Adjust/Set
- Maintenance
- Troubleshooting
- Others
- Quick Start Guide
- External Command Communication Specification
- 1 Outline
- 2 Interface
- 3 Protocol
- 4 Command control
- 4.1 NULL command
- 4.2 Power [PoWer]
- 4.3 Input [InPut]
- 4.4 Remote control pass-through [RemoteCode]
- 4.5 Setup [SetUp]
- 4.6 Gamma data of Gamma table “Custom 1/2/3” [GammaRed, Green, Blue]
- 4.7 Panel Alignment (zone) Data [Panel Alignment(Zone) Red, Blue]
- 4.8 Source Asking [SourCe]
- 4.9 Model status asking [MoDel]
- 4.10 Adjustment [AdjustmentCommand]
- Command code
- Parameter1
- Parameter2
- 4.10.1 Special data
- Special data
- Picture mode
- Color Profile
- Color Temp. Table Data
- Color Temp. Correction Data
- Gamma Table Data
- Gamma Correction Data
- Dynamic Control Data
- Color Management Data
- Low Latency Data
- Clear Motion Drive Data
- Motion Enhance Data
- LD Power Data
- Graphic Mode Data
- HDMI Input Level Data
- HDMI Color Space Data
- HDMI 2D/3D Data
- Aspect Data
- Mask Data
- Lens Control(Focus Near, Focus Far, Zoom Tele, Zoom Wide, Shift Left, Shift Right, Shift Up, Shift Down) Data
- Lens Image Pattern, Lens Lock, Screen Adjust, Uniformity Correction Data
- Installation Style Data
- Anamorphic Data
- Panel Alignment Switch Data
- High Altitude mode
- Back Color Data
- Menu Position Data
- Source Display
- Language Data
- Trigger Data
- Off Timer Data
- Eco Mode Data
- Control 4 Data
- Input Data
- Source Data
- Deep Color Data
- Color Space Data
- Colorimetry Data
- HDR Data
- 4.10.2 Special2 Data
- 4.10.3 Special3 Data
- 4.10.4 Special9 Data
- 4.10.5 Special10 Data
- 4.10.6 Special14 Data
- 4.10.7 Operation
- 4.10.8 Reference
- LAN setup [Lan Setup]
- Screen Codes
- Safety Precautions
¿»Í¿Ä½¿º»ÅÉ
·Á»ÉËÈ»ÊÅÈ»ÃÅ̻ʾ»Â»ÄɹÅÌ»ÈƔ
ÅÄÄ»¹Êʾ»ÆÅͻȹÅȺƑ·Äº»ÄÉËȻʾ·Êʾ»ơƭƢ¿Äº¿¹·ÊÅÈ
¿½¾ÊÉËÆ¿ÄÈ»ºƔ
ËȿĽÉʷĺ¸Ï¿Äʾ»ơź»ƢƑʾ»ơƭƢ¿Äº¿¹·ÊÅȺŻÉÄÅÊ
¿½¾ÊËƻ̻Ä;»Äʾ»ÆÅͻȹÅȺ¿É¹ÅÈÈ»¹ÊÂϹÅÄÄ»¹Ê»ºƔ
Äʾ¿É¹·É»Ƒ¹·Ä¹»Âʾ»Éʷĺ¸ÏÃź»¸ÏÆÈ»ÉɿĽ·ÄϸËÊÊÅÄÅÄʾ»È»ÃÅÊ»
¹ÅÄÊÈÅÂËÄ¿ÊƑÅÈËɻʾ»¸ËÊÊÅÄÅÄʾ»ÆÈÅÀ»¹ÊÅÈËÄ¿Ê;»ÄÏÅË·È»ÊËÈĿĽ
ÅÄʾ»ÆÅÍ»ÈƔ
ËÈÄÅÄʾ»ÆÅÍ»È
»ÃÅÊ»¹ÅÄÊÈÅÂƓÆÈ»ÉÉʾ»ƾƿ¸ËÊÊÅÄ
ÈÅÀ»¹ÊÅÈËÄ¿ÊƓÆÈ»ÉÉʾ»¸ËÊÊÅÄ
¾»ơƭƢ¿Äº¿¹·ÊÅÈ¿½¾ÊÉͿʹ¾»É¼ÈÅÃÈ»ºƺ¿½¾Êż¼¿Ä
ơź»ƢƻÊŽȻ»Äƺ¿½¾Ê½Å»Éż¼·¼Ê»Èʾ»ËÄ¿ÊÉÊ·ÈÊÉËÆƻƔ
LIGHTWARNING
STANDBY/ON
LIGHTWARNING
STANDBY/ON
LIGHTWARNING
STANDBY/ON
DB
AND
BY/
DB
AND
BY/
When in “ECO Mode”
“STANDBY/ON” light off
When LD block is starting up
“STANDBY/ON” lights up (green)
In standby state
“STANDBY/ON” lights up (red)
¾ÅÅɻʾ»¿Ã·½»ÊÅÆÈÅÀ»¹Ê
»ÃÅÊ»¹ÅÄÊÈÅÂƓÆÈ»ÉÉʾ»ƾʸƿÅÈƾʹƿ¸ËÊÊÅÄ
ÈÅÀ»¹ÊÅÈËÄ¿ÊƓÆÈ»ÉÉʾ»ƾƿ¸ËÊÊÅÄÊÅÉͿʹ¾Ê¾»¿ÄÆËÊ
·ϸ·¹Áʾ»É»Â»¹Ê»ºº»Ì¿¹»ÊÅÆÈÅÀ»¹Êʾ»¿Ã·½»Ɣ
ËÈÄż¼Ê¾»ÆÅÍ»È
»ÃÅÊ»¹ÅÄÊÈÅÂƓÆÈ»ÉÉʾ»ƾƿ¸ËÊÊÅÄ
ÈÅÀ»¹ÊÅÈËÄ¿ÊƓÆÈ»ÉÉʾ»¸ËÊÊÅÄ
¾¿Â»Ê¾»ơÈ»ÏÅËÉËÈ»ÏÅËÍ·ÄÊÊÅÊËÈÄż¼ƜƢûÉÉ·½»¿Éº¿ÉÆ·ϻºƑ
ÆÈ»ÉÉʾ»¸ËÊÊÅÄ·½·¿ÄƔ
¾»Â¿½¾Êżʾ»¸ÂŹÁ½Å»Éż¼Ƒ·ÄºÊ¾»ơƭƢ¿Äº¿¹·ÊÅÈ
ÉͿʹ¾»É¼ÈÅ÷½È»»Ä¿½¾ÊÊÅ·È»º¸Â¿ÄÁ¿Ä½Â¿½¾ÊƔ
¼Ê»Èʾ»Â¿½¾Ê½Å»Éż¼Ƒʾ»¼·ÄÍ¿ÂÂÈËļÅÈ·¸ÅËÊʸʷÉ»¹ÅĺÉÊŹÅÅÂ
ºÅÍÄʾ»¸ÂŹÁƺÅÅÂƖºÅÍÄÃź»ƻƔÅÄÅʺ¿É¹ÅÄÄ»¹Êʾ»ÆÅÍ»È
¹·¸Â»Í¾¿Â»¹ÅÅ¿Ľ¿É¿ÄÆÈŽȻÉÉƔ
¼Ê»È·¸ÅËÊʸʷÉ»¹ÅĺÉƑʾ»ơƭƢ¿Äº¿¹·ÊÅÈÉͿʹ¾»É¼ÈÅÃ
·¸Â¿ÄÁ¿Ä½È»ºÊÅ·ÉÅ¿ºÈ»ºÂ¿½¾ÊƔ
LIGHTWARNING
STANDBY/ON
DB
AND
BY/O
LIGHTWARNING
STANDBY/ON
In standby state
“STANDBY/ON” lights up (red)
In the Cool-down mode
“STANDBY/ON” blinking (red)
ÊÊ·¹¾Ê¾»Â»ÄɹÅÌ»ÈƔ
¾»ÆÅͻȹ·ÄÄÅʸ»ÊËÈÄ»ºÅ¼¼Í¿Ê¾¿Ä·ÆÆÈÅο÷ʻÂÏʺʷÉ»¹Åĺɷ¼Ê»È¿Ê
¾·É¸»»ÄÊËÈÄ»ºÅÄƔ
¾»ÆÅͻȹ·ÄÄÅʸ»ÊËÈÄ»ºÅÄ·½·¿Ä;¿Â»¹ÅÅ¿Ľ¿É¿ÄÆÈŽȻÉÉƺʸʷ
É»¹ÅĺÉƻƔ
ËÂÂÅËÊʾ»ÆÅÍ»ÈÆÂ˽;»Äʾ»ËÄ¿Ê¿ÉÄÅÊÊŸ»ËÉ»º¼ÅÈ·ÆÈÅÂÅĽ»º
ƻȿźżʿûƔ
¼Ê¾»¿Äº¿¹·Ê¿ÅÄż¿Äº¿¹·ÊÅȺ¿¼¼»ÈɼÈÅÃʾ»º»É¹È¿ÆÊ¿ÅÄƑÈ»¼»ÈÊÅơĺ¿¹·ÊÅÈ
¿ÉÆ·ÏÅÄʾ»·¿ÄÄ¿ÊƢƔʸʷ¼ÅȺ»Ê·¿ÂÉƔ
LIGHTWARNING
STANDBY/ON
SETTING MEMORY
MODE 1 MODE 2 MODE 3
1
1 3 2
2
3
This unit
Remote Control
6