OperationManual

3
Turn off the power
Projector unit: press the A [STANDBY/ON] button
Remote control (sold separately): press the B [STAND BY] button
0
While the “Are you sure you want to turn off?” message is displayed, press the button again.
0
The
laser
light source turns off, and the “STANDBY/ON” indicator switches from a green light to a red blinking
light.
0
After the light goes off, the fan will run for about 5 seconds to cool down the laser light source (Cool-down
mode).
Do not disconnect the power cable while cooling is in progress.
0
After about 5 seconds, the “STANDBY/ON” indicator switches from a blinking red to a solid red light.
LIGHT WARNING
STANDBY/ON
LIGHT
WARNING
STANDBY/ON
ND
TAN
DBY
In standby state
“STANDBY/ON” lights up (red)
In the Cool-down mode
“STANDBY/ON” blinking (red)
CAUTION
0
After the light goes off, the fan will run for about 5 seconds to cool down the laser light source (Cool-down mode).
Do not disconnect the power cable while cooling is in progress.
0
The power cannot be turned on again while cooling is in progress (5 seconds).
0
Pull out the power plug when the unit is not to be used for a prolonged period of time.
0
If
the
Auto Intensity function is On, the cool-down time increases depending on the usage condition of the projector.
23
Operate