OperationManual

LED Indication
When “LED Indication” is set to “Off”, the LED indicator does not light up or blink under the following status.
0
When the time to replace the laser light source is near. (
P. 48)
0
When HIDE is on. (P.
70)
0
When the projector receives a signal from a remote control which is set to a different code mode (A or B). (
P. 47)
High Altitude Mode
For setting the high altitude mode to “On” or “Off”.
Set to “On” when using the projector at a location of low atmospheric pressure (higher than 900 m above sea level).
Auto Geometry Stabilizer
For correcting the phase shifting between each RGB color due to the temperature according to the duration after starting
up.
Phase
shift correction is performed every minute for 120 minutes from startup according to the preconfigured correction
value.
0
When this function is used, up to 4 pixels on either the left or right end will be missing depending on the amount of
correction.
Mode
For configuring the correction feature to On or Off.
0
The menu options under “Adjust” are not available when “Mode” is configured to “Off”.
0
“Adjust (Pixel)” of “Pixel Adjust” is not available when “Mode” is configured to “On”.
Adjust Pattern
Setting Description
Off Displays the external signals without displaying the test pattern for adjustment.
On Displays the test pattern for adjustment.
Adjust
For configuring the correction value according to the current time.
0
Correction values can be configured for up to four points.
0
After
configuration of the correction values for the four points is complete, “Adjust” will not be selectable. To configure
the setting, do so after erasing the unwanted correction values.
Setting Description
H (Horizontal) Setting range: -4 (moves Red/Green/Blue to the left) to +4 (moves Red/Green/Blue
to the right)
V (Vertical) Setting range: -4 (moves Red/Green/Blue downward) to +4 (moves Red/Green/
Blue upward)
Point 1 to 4
For editing or erasing preconfigured correction values directly.
The configured time is displayed in “Point 1 to 4” after configuration of the correction values is complete.
Reset
For erasing the preconfigured correction values in Point 1 to 4.
43
Adjust/Set