OperationManual

About the Lens
0
This projector does not come with a projection lens.
To use the projector, please mount a projection lens according to your requirements.
0
When
using an optional standard zoom lens or short focus lens, a spacer and shift plate are required. Use the spacer
that comes with this unit. The shift plate varies depending on the tilting angle of the lens so please contact our sales
representative.
0
To use the Shift function, a motorized lens shift unit is required. (Sold separately)
<Optional Extras>
Standard zoom lens (product no.: GL-MZ4014SZ)
Short focus lens (product no.: GL-MZ4009SZ)
Motorized lens shift unit (product no.: PK-MLS01)
Mounting the Lens
When installing the lens using the shift plate, do so according to the following procedures.
When using the optional motorized lens shift unit (PK-MLS01), refer to its instruction manual.
CAUTION
0
Before
attaching the lens, check to make sure that the power of the projector is not turned on and the power cord is
not connected. Failure to do so may cause electric shock or injuries.
0
When using the projector in an environment where vibration occurs continuously, tighten the mounting screws
periodically or apply treatment to the screws for mounting before use to prevent them from loosening.
* The recommended tightening torque for the screws for mounting the lens is 1.47N・m (15kgf・cm).
1
Unscrew the 4 screws using a Phillips screwdriver to remove the front cover
Front Cover
51
Maintenance