DVD Video Recorder Instructions

Filename [DR-M10AG_AX_AA2_06Name.fm]
Masterpage:Left+
20 EN
Page 20 April 27, 2004 10:56 am
INITIAL SETTINGS (cont.)
D
Perform Auto Channel Set.
Press ENTER.
● Receivable channels in your area are automatically assigned to
the CH +/– buttons, and non-receivable channels are skipped.
● When Auto Set Up is completed, the lowest position number
will appear on the front display panel. If “SCAN COMPLETED
–NO SIGNAL–” is displayed on the TV screen, make sure that
the aerial cable is connected to the unit properly and press
ENTER on the remote control. The unit will try Auto Set Up
again.
NOTES:
● If there is a power cut, or if you press 1 or SET UP while Auto
Set Up is in progress, Auto Set Up will be interrupted; be sure
to turn off the unit power once and try again from step A.
● If no sound accompanies the picture or the audio sounds
unnatural on some channels that have been stored by Auto Set
Up, the TV system setting for those channels may be incorrect.
Select the appropriate TV system for those channels.
(墌 pg. 95, “TV System Selection — When you see the picture
but the audio can’t be heard or sounds unnatural”)
DO NOT press any button on the unit or remote control
while Auto Set Up is in progress.
A
TTENTION:
If you perform Auto Set Up successfully during installation,
there’s no need to separately perform the Clock Set or
Channel Set procedures, but if adjustments become
necessary, they can be performed as follows:
● Language setting (墌 pg. 22)
● Tuner setting (墌 pg. 92)
● Clock setting (墌 pg. 96)
After “Auto Set Up” is completed, perform “Monitor
Set” on page 21.
DR-M10SAG_AX_AA2_01.book Page 20 Thursday, May 6, 2004 10:46 AM