User's Manual

19
Getting Started
EN
Move
You can replace two channels.
1 In stop mode, press [SET UP].
2 Select “Advanced Setting Menu”
using [Cursor U / D], then press
[ENTER].
If it has already appeared, proceed to step 3.
3 Select “Channel” using
[Cursor U / D], then press [ENTER].
4 Select “Move” using [Cursor U / D],
then press [ENTER].
5 Select the position number of which
you want to change the channel
using [Cursor U / D], then press
[ENTER].
You cannot select a position number where
“– – –” appears next to the number, because
“Skip” is set to “ON” for that position number.
6 Move the channel to another
position number using
[Cursor U / D], then press [ENTER].
• To move another channel, repeat steps 5 to 6.
7 Press [SET UP] to exit.
Setting the clock
Clock Setting
1 In stop mode, press [SET UP].
“Easy Setting Menu” or “Advanced Setting Menu”
will appear.
2 Select “Clock” using [Cursor U / D],
then press [ENTER].
3 If you select “Advanced Setting
Menu,” proceed to step 4.
If you select “Easy Setting Menu,”
proceed to step 5.
4 Press [ENTER].
5 Press [ENTER] again.
The default date will appear.
6 Enter the date (day / month / year)
using [Cursor U / D], then press
[Cursor P].
Press [Cursor P] to move the cursor to the next
field. If you wish to go back to the previous field,
press [Cursor L].
7 Enter the time (hours / minutes)
using [Cursor U / D], then press
[ENTER].
The clock will start.
• Although seconds are not displayed, they will be
counted from zero.
8 Press [SET UP] to exit.
Note
• Your clock setting will be lost if either there is a
power failure or the unit is unplugged for more than
30 seconds.
Clock Setting
)
0: 00
01
/ 01/ 2005(SAT)
E6850ED_EN.book Page 19 Wednesday, August 3, 2005 4:02 PM