Owner`s manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Introduction
- Hookup and Settings
- Connecting an Antenna or Cable TV
- Connections to your TV
- Connection to an Amplifier
- Accessory Audio/Video (A/V) Connections to Recorder
- Connecting a Digital Camcorder
- Initial Setup Wizard
- Using the Home Menu
- Initial Settings
- General Settings
- Language Settings
- Audio Settings
- Lock (Parental Control) Settings
- Recording Settings
- Disc Settings
- TV Viewing
- Playback
- Recording
- About DVD recording
- Notes for recording
- Recording time and picture quality
- Basic Recording from a TV
- Instant Timer Recording
- Timer Recording
- Basic Recording from a TV
- Instant Timer Recording
- Timer Recording
- Dubbing from DVD to VCR
- Dubbing from VCR to DVD
- Recording from External Components
- Recording from DV Input
- Editing
- Title List and Chapter List Menu Overview
- VR Mode: Original and Playlist Editing
- Adding Chapter Markers
- Changing the Title Thumbnails
- Making a New Playlist
- Adding Additional Title / Chapters to the Playlist
- Deleting an Original or Playlist Title/Chapter
- Deleting a Part
- Naming a Title
- Time Search
- Moving a Playlist Chapter
- Hide a Chapter/Title
- Protect a Title
- Divide One Title Into Two
- Combining Two Chapters Into One
- Overwriting Recording
- Viewing Title List menu displayed on other DVD Recorders or Players
- Playing Your Recordings on Other DVD Players (Finalizing a Disc)
- Reference
36
Timer Recording Troubleshooting
Even though the timer is set, the recorder will not
record when:
• There is no disc (or tape) loaded.
•Anon-recordable disc (or tape) is loaded.
• Disc Protect is set to [ON] in the Disc menu
(see page 22).
• There are already 99 titles (DVD-RW, DVD-R,
DVD-RAM), 49 titles (DVD+RW, DVD+R)
recorded on the disc.
You cannot enter a timer program when:
•Arecording is already underway.
• The time you’re trying to set has already
passed.
• There are already 16 timer programs set.
If two or more timer programs overlap:
• The earlier program takes priority.
• When the earlier program finishes, the later
program starts.
• If two programs are set to start at exactly the
same time, the program entered first takes
priority.
If the disc is damaged, the recording may not
complete successfully. In this case even though the
Check field shows [Rec. OK], it may not be.
Note:
Recording programs that are blocked through
Parental Lock or TV Ratings will present the following
message: "Cannot Record-No Input Signal". Please
disable/ adjust the TV Rating (See page 20) or the
Parental Lock (See page 19) before recording the
program when you want to record.