Owner`s manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Introduction
- Hookup and Settings
- Connecting an Antenna or Cable TV
- Connections to your TV
- Connection to an Amplifier
- Accessory Audio/Video (A/V) Connections to Recorder
- Connecting a Digital Camcorder
- Initial Setup Wizard
- Using the Home Menu
- Initial Settings
- General Settings
- Language Settings
- Audio Settings
- Lock (Parental Control) Settings
- Recording Settings
- Disc Settings
- TV Viewing
- Playback
- Recording
- About DVD recording
- Notes for recording
- Recording time and picture quality
- Basic Recording from a TV
- Instant Timer Recording
- Timer Recording
- Basic Recording from a TV
- Instant Timer Recording
- Timer Recording
- Dubbing from DVD to VCR
- Dubbing from VCR to DVD
- Recording from External Components
- Recording from DV Input
- Editing
- Title List and Chapter List Menu Overview
- VR Mode: Original and Playlist Editing
- Adding Chapter Markers
- Changing the Title Thumbnails
- Making a New Playlist
- Adding Additional Title / Chapters to the Playlist
- Deleting an Original or Playlist Title/Chapter
- Deleting a Part
- Naming a Title
- Time Search
- Moving a Playlist Chapter
- Hide a Chapter/Title
- Protect a Title
- Divide One Title Into Two
- Combining Two Chapters Into One
- Overwriting Recording
- Viewing Title List menu displayed on other DVD Recorders or Players
- Playing Your Recordings on Other DVD Players (Finalizing a Disc)
- Reference
50
Symptom
The Recorder does not
start playback.
Video tape cannot be
inserted.
The Remote Control
does not work properly.
Camcorder image is
not shown.
Camcorder image via
A/V input or DV IN to
Recorder is not shown
on TV screen.
Timer recording is not
possible.
Cause
No disc is inserted.
No tape is inserted.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the
guide.
The disc is dirty.
The Rating level is set.
A cassette tape was inside already.
There is an obstacle in the path of the
Remote Control and this unit.
The batteries in the Remote Control
are exhausted.
The Remote Control is not pointed at
the remote sensor of the Recorder.
The Remote Control is too far from
the Recorder.
This Remote Control use the same
buttons for VCR and DVD functions
(ex.PLAY).
The current remote control code dose
not match the unit.
Camcorder is off.
The recorder’s source is incorrect.
Clock in record is not set to
correct time.
Timer has been programmed
incorrectly.
(TIMER Record) indicator light does
not appear after programming timer.
Correction
Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
Insert a playable disc. (Check the disc
type and Regional code.)
Place the disc with the playback side
down.
Place the disc on the disc tray correctly
inside the guide.
Clean the disc.
Cancel the Rating function or change
the rating level.
Eject the tape first and then insert the
tape you want to use.
Remove the obstacle.
Replace the batteries with new ones.
Point the Remote Control at the remote
sensor of the Recorder.
Operate the Remote Control within
23ft (7m).
When using a VCR, first press the VCR
button. When using a DVD, first press
the DVD button.
Identify the remote control code with
the code of unit (See page 25).
Turn camcorder on and operate
properly.
Use AUX to select input channel (AV1,
AV2 or DV IN).
Set clock to correct time.
Reprogram Timer.
Reprogram Timer and turn the
Recorder off to enable timer.