Instructions

Filename [DR-MV1SU_09Editing.fm]
Masterpage:Left0
72 EN
Page 72 February 23, 2004 4:32 pm
SYSTEM CONNECTIONS
These instructions enable you to connect your unit to a Dolby
Digital decoder or an amplifier with built-in DTS.
1 Connect the unit and a Dolby Digital decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
DIGITAL/PCM”. (
墌 pg. 73)
● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
(
墌 pg. 73)
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
● Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
1
Note for connection:
Remove the protection cap from the
cable.
Optical cable
(not supplied)
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not supplied)
DIGITAL AUDIO OUT (COAXIAL)
DIGITAL AUDIO OUT (OPTICAL)
DR-MV1SU_00.book Page 72 Tuesday, February 24, 2004 12:53 PM