DVD Video Recorder & Video Cassette Recorder Instructions

Filename [MV4S_12RemoSys.fm]

Masterpage:Left0

68 EN

Page 68 Monday, 9 May 2005 09:42

REMOTE CONTROL

Remote Control 1/2/3/4 Code Switching

The remote control is capable of controlling four JVC video units

independently. Each of the units can respond to one of four codes

(1, 2, 3 or 4). The remote control is preset to send 3 code signals

because your unit is initially set to respond to 3 code signals. You

can easily modify your unit to respond to 1, 2 or 4 code signals.

● Keep pressing SET UP down during step 1.

1 Press the number button “1” for 1, “2” for 2, “3” for 3 or “4”

for 4 to change the remote control code, then press ENTER.

2 Press 1 on the unit to turn off the unit.

3 Press 4 on the unit for over 5 seconds while the unit is turned

off. The code currently set appears on the front display panel.

4 Press 8 on the remote control to change the unit’s code. The

code currently set on the remote control blinks on the front display

panel for approximately 5 seconds, and is applied to the unit.

NOTE:

When “POWER SAVE” is set to “ON” (墌 pg. 71), it is not possible to

change the remote code.

Controlling your TV (only for JVC TVs)

The remote control can operate your JVC TV. Turning power on/off,

changing input mode, selecting channel and volume setting are

possible. Other manufacturer’s TVs cannot be operated by this

remote control.

Remote Control Functions

ENTER

SET UP

1 – 4

VHS/DVD

DVDVHS

REC

VHS DVDDUBBING

STANDBY/ON

S-VIDEO VIDEO AUDIO

ONE-TOUCH EXPERT DUB

DVD

(MONO)

−

TV CH +/–

TV VOL +/–

TV INPUT

MV4S_12RemoSys.fm Page 68 Monday, May 9, 2005 9:42 AM