Operation Manual

Filename [DR-M10U_06-2Initial Set.fm]
Masterpage:Left+
30 EN
Page 30 March 4, 2004 5:15 pm
INITIAL SETTINGS (cont.)
Setting cable box’s brand and channel
After installation, set the cable box’s brand and channel
correctly; otherwise, the Controller cannot work
correctly.
A
Turn on the cable box.
Turn on the cable box’s power.
B
Access the Main Menu screen.
Press SET UP.
C
Access the “CABLE BOX SET” screen.
D
Select the cable box’s channel.
Your selection depends on
how the cable box is
connected to your unit.
A Press rt to move the
arrow to “CABLE BOX
OUTPUT CH”, then press
ENTER.
B If the cable box is
connected to your unit’s ANTENNA IN connector on
the rear panel, press rt to select the channel
number representing the cable box’s output (CH2 –
CH9), then press ENTER.
If the cable box is connected to your unit’s AUDIO/
VIDEO INPUT connectors on the rear panel, press
rt to select “L-1” or “L-2”, then press ENTER.
If you do not use a cable box, press rt to select
“OFF”, then press ENTER.
CABLE/DBS
DVDTV
DVD
CH
TIMER REC LINK PROG/CHECK VCR Plus+
NEXTPREVIOUS
PAUSEREC
REC MODE LIVE CHECK
SET UP DISPLAY ON SCREEN
OPEN/
CLOSE
AUDIO SUBTITLE ANGLE
PROGRESSIVE
SCAN
SLOWSLOW PLAY/SELECT
STOP/
CLEAR
NAVIGATIONTOP MENU
RETURN
ENTER
MENU
TV/CBL/DBS
STANDBY/ON
TV
MUTING
TV/
VIDEO
TV VOLUME
ABC
JKLGHI MNO
TUVPQRS WXYZ
AUXCANCEL MEMO/MARK
DBS
DEF
rtwe
ENTER
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/DBS/DVD switch to DVD.
A Press we to move the
arrow to “INITIAL SET
UP”, then press ENTER.
B Press we to move the
arrow to “STB SET”, then
press ENTER.
C Press rt to move the
arrow to “CABLE BOX
SET”, then press ENTER.
DR-M10U_06-2Initial Set.fm Page 30 Thursday, March 4, 2004 5:15 PM