Manual

Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC
service center
PROBLEM POSSIBLE CAUSE
3]ae display does not light up. The power cord is not plugged in.
No sound from speakers. Speaker signal cables are not connected.
Sound from one speaker only.
Contirmous hiss or buzzing during FM
reception.
SOLUTION
Plug the power cord into an AC outlet.
Check speaker wiring and reconnect if
necessary.
Press SPEAKERS 1 and 2 correctly.
The SPEAKERS 1 and 2 buttons are not
set correctly.
An incorrect source is selected.
Muting is activated.
Speaker signal cables are not connected
properly.
The balance is set to one extreme.
Incoming signal is too weak.
The station is too lhr away.
An incorrect antenna is used.
Select the correct source.
Press MUTING to cancel the mute.
Check speaker wiring and reconnect if
necessary.
At[just the balance properly (see page 12).
Connect an outside FM antenna or contact
your dealer.
Select a new station.
Check with your dealer to be sure you have
the correct antenna.
Antennas are not connected properly. Check connections.
Occasional cracking noise during FM Ignition noise from automobiles. Move the antenna farther from automobile
reception, traffic.
No colors on the on-screen display. The color system of the connected TV is Connect an NTSC TV.
not NTSE.
ltowling during record playing. Your turntable is too close to speakers. Move speakers away l?om the turntable.
"OVERLOAD" starts flashing on the
display.
Speakers are overloaded because of high
volume.
Speakers are overloaded because of short
circuit of speaker terminals.
The remote control mode selector is not
set correctly.
Rotate the MASTER VOLUME control
counterclockwise three or four times, then
press POWER on the front paneh
If "OVERLOAD" does not disappear, unplug
the AC power cord, then plug it back again.
Remote control does not work.
Press POWER on the front panel, then check
the speaker wiring.
If "OVERLOAD" does not disappear, unplug
the AC power cord, then plug it back again.
If speaker wiring is not short-circuited, contact
your dealer.
Set the selector correctly either to "AUDIO/
TV/VE R" or to "CATV/DBS."
There is an obstruction in lkont of the Remove the obstruction.
remote sensor on the receiver.
Batteries are weak. Replace batteries.
45