Manual

4. Adjust the speaker output levels. - CENTER+
• _1_adjust the center speaker level, press O_O
CENTER/+ (from 10 dB to +10 dB).
• _1_adjust the left rear speaker level, press
REAR,L/+ (from 10 dB to +10 dB). - REARoL_
• _1_adjust the right rear speaker level, press
P.EAR.R /+(from 10dB to +10 dB). O _
_ REA_ _
5. Press TEST again to stop the test TEST
tone. %
On the front panel:
You can also use the buttons on the fiont panel to adjust the
Surround modes. However, no test tone is available when using the
buttons on the front panel. So, make adjustments while listening to
the sound of the source played back,
1. Press SURROUND to active an _ ........
appropriate Surround mode -- _,_- x_
PRO LOGIC, DOLBY DIGITAL
or DTS SURROUND.
• Each time you press the button, the Surround mode turns on
and off alternately.
• When "PRO LOGIC" is selected, the t]D PRO LOGIC
indicator lights up on the display.
2. Adjust the speaker output levels.
1) Press ADJ UST repeatedly until one of
the tbllowing indications appears on
the display.
"CENTER LEVEL":
_1_adjust the center speaker level,
"REAR L LEVEL":
_1_adjust the left rear speaker level.
"REAR R LEVEL":
_1_adjust the right rear speaker level.
• Once yon have pressed ADJUST,
MULTI CURSOR A / V can be also
used for selecting the speaker.
2) Press MULTI CURSOR <_ / _ to
adjust the selected speaker output level
(from -10 dB to +10 dB).
3) Repeat 1) and 2) to adjust the other
speaker output levels.
ADJUST
%
JVC Theater Surround adjustments
Beibre you start, remember...
• Make sure that you have set the speaker intbrmation correctly
(see page 12).
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
• You cannot adjust the rear speaker output levels when you have set
"REAR SPK" to "NONE," See page 12.
• You cannot adjust the center speaker output level and center tone
when you have set "CENTER SPK" to "NONE." See page 12.
From the remote control:
1, Press SURROUND MODE
repeatedly until "THEATER"
appears on the display-.
• The DDPRO LOGICand DSP indicators
also light up on the display.
.
3.
Press SOUND. SOUND
The 10 keys are activated for sound adjustments.
Press TEST to check the speaker TEST
output balance. %
"TEST TONE L" starts flashing on the
display, and a test tone comes out of the
speakers in the following order:
rTEST TONE L .__TEST TONE C .__TEST TONE R
(Left front speaker) (Center speaker) (Right front speaker) |
/
TEST TONE LS. TEST TONE RS I
(Left rear speaker) (Right rear speaker)
Notes:
• You can adjust the speaker output levels without outputting the
test tone.
• No test tone comes out of the center speaker when "CENTER
SPK" is set to "NONE" (see page 12).
• No test tone comes out of the rear speakers when "REAR SPK"
is set to "NONE" (see page 12).
23