Manual

/
=%
When you use the digital input terminals, register what components
are connected to which terminals (DIGI'IAL 1/2) so that the correct
source name will appear when you select the digital source.
Betbre you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step I again.
1 Press SETTING repeatedly until .......
"DIGITAL IN" appears on the display. _N_'>
Then the display changes to show the current setting.
When you have connected digital source components using both the
analog connections (see page 6) and the digital connections (see
page 7) methods, you need to select the input mode correctly.
1 Press one of the source selecting buttons--DVD,
TV SOUND, CD, or TAPE/CDR*--for which you
want to change the input mode.
DIGITAL 2 terminal setting .........
%>
I
I
, 31/ 3 2[- 3 Onthefront panel
DIGITAL 1 terminal setting
* "l DVD 2CD" is the initial setting. If you have already
changed the setting, another combination will be shown.
,2 Press CONTROL UP A/DOWN • to ......
_JowN u_
select the appropriate digital terminal
setting. %>
• Each time you press the button, the display
changes as folk)ws:
1 DVD2CD _ l DVD2TV_ l DVD2CDR
1 CD 2DVD¢"_ l CD 2TV_ l CD 2CDR
1TV 2DVD¢"_ 1TV 2CD0"_ 1TV 2CDR¢"_
1 CDR2DVD_ 1 CDR2CD_ 1 CDR2TV
(back to the beginning)
Note:
When shipped from the factory, the DIGITAL IN terminals can be used
as the digital input for the following components:
-DIGITAL I (coaxial): For DVD player
-DIGITAL 2 (optical): For CD player
TApFJCDR CD DVD
TV SOUND
From the remote control
Note:
* Among the sources listed above, you can select the digitalinput
only for the sources which you have selected the digital input
terminals fo_ (See "Setting the Digital Input (DIGITAL IN)
Terminals" on the left column.)
Select digital input mode.
Iln the front panel:
Press INPUT DIGITAL.
"DIGITAL AUTO" appears on the display and
the indicator for the detected signals also lights
up.
s_x
D_=rAL,U_ODDE]
L_[_ TIT I'- T T I I T n
E×: With the incoming signNs of Linear PCM
To change the input mode back to analog
input, press INPUT ANALOG.
"ANALOG" appears on the display and the
analog indicator also lights up.
INPUT ANALOG
TO BE CONTINUED ON THE NEXT PAGE 11