Manual

Basic S÷ttings
Fromtheremotecontrol: ANALOQ
/DIGITAL
Press ANALOG/DIGITAL. _=_
The current setting indication appears on the display.
• Each time you press the button, the input ]node alternates
between the analog input ("ANALOG") and the digital input
("DIGITAL AUTO").
ANALOG : Select this for the analog input ]node.
(Initial setting when shipped from the
factory.)
If the fbllowing symptoms occur while playing Dolby Digital or
DTS Digital Surround software with "DIGITAL AUTO"
selected, tbllow the procedure below:
Sound does not come out at the beginning of playback.
- Noise comes out while searching or skipping chapters or tracks.
I Press INPUT DIGITAL (or ANALOG/DIGrFAL on the remote
contml).
"DIGflAL AUTO" appears on the display.
ANALOG
INPUT DIGITAL /DIGITAL
On the front panel From the remote control
2 Press CONTROL UP A/DOWN • to select [_]
"DOLBY DIGITAL" or "DTS SURROUND"
while "DIGITAL AUTO" still remains on the
display co_,o,
- eow_ uP
• Each time you press the button, the digital input
mode changes as follows:
When "DOLBY DIGITAL" or "DTS
SURROUND" is selected, "DIGITAL AUTO" goes off.
I I TRL RUTE]
• 'Ii) play back software encoded with Dolby Digital, select
"DOLBY DIGfI'AL"
• To play back software encoded with DTS Digital Surround,
select "DTS SURROUND?'
Note:
When you turn off the power or select another source, "DOLBY
DIGITAL" and "DTS SURROUND" are canceled and the digital input
mode is automatically reset to "DIGITAL AUTO."
The following are the analog/digital signal indicators on the display to
indicate what type of the signal comes into the receiveL
ANALOG : Lights when the analog input is selected.
LINEAR PCM : Lights when Linear PCM signals come in.
F]["l DIGITAL : • Lights when Dolhy Digital signals come in.
• Flashes when "DOLBY DIGfIAL" is
selected for software not encoded with Dolby
Digital signals.
dl_ : • Lights when DTS signals come in.
• Flashes when "DTS SURROUND" is
selected for software not encoded with DTS
signals.
Note:
When "DIGITAL AUTO"cannot recognize the incoming signals, no
digital signal indicator lights up on the display.
To obtain the best possible sound or effect from Surround modes
(see page 21-23), register the following speakers and subwoofer
information after all connections are completed.
'Ihe following are items you can set:
Subwoofer information SUBWOOFER
Speaker size FRNT SP, CNTR SR REAR SP
Speaker distance_N1T, FRNT DIS, CNTR DIS, REAR DIS
Crossover Irequency_ROSS
Low frequency effect attenuator--LFE ATT
Dynamic range compression--D. COMP
Before you start, remember...
'1here is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step [ again.
"NO" for the subwoofer, "LARGE" for the front speakers,
and "SMALL" tbr the center and rear speakers are initial
settings. To get best possible sound, change the subwoofer and
speaker settings to fit your listening conditions.
Suhwoofer information
Register whether you have connected a suhwooler or not.
I Press SETTING repeatedly until .......
"SUBWOOFER" (with the current _'x_'_
setting) appears on the display.
Press CONTROL UP A_OWN • .......
DOWN UP
to register whether you have
connected a subwoofer or not. _'_
• Each time you press the button, the
subwoofer setting alternates between "YES" and "NO?'
NO
: Select this when you have not connected or have
disconnected a subwoofer.
12