Manual

Speaker size
Register the sizesof all the connected speakers.
• When you changeyour speakers,register the in_rmation about the
speakersagain.
!
Press SETTING repeatedly until ......
"FRNT SP (Front speaker)," "CNTR _K_'_
SP (Center speaker)," or "REAR SP
(Rear speaker)" (with the current setting)
appears on the display.
2
Press CONTROL UP A/DOWN • to .......
eow_ up
select the appropriate item about the
speaker selected in the above step.
• Each time you press the button, the display
changes as follows:
[_ LARGE <"_"_" SMALL _'_ I
_, NONE
/
Speaker distance
Register the unit you use, then the speaker distance from your
listening point.
• If you have set the unit before, start from step 3.
• Speaker distance is not valid for the DVD MULTI playback mode.
! Press SETTING repeatedly until ......
"UNIT" (with the current setting)* _x_'_
appears on the display.
* "METER" is the initial setting. If you have already changed the
setting, "FEET" will be shown.
Press CONTROL UP A/DOWN • to ......
oow_ u_
select the unit.
• Each time you press the button, the setting _x_
alternates between "METER" and "IaEET. ''
FEET : Speaker distance is shown in feet.
SMALL : Select this when the speaker size is relatively small.
(See "Notes" below0
3 Repeat step 1 and 2 to select the appropriate
items for other speakers.
Notes:
• Keep the following comment in mind as reference when adjusting.
- ff the size of the cone speaker unit built in your speaker is greater
than 12 cm (4 3/_inches), select "LARGE," and if it is smaller than
12 cm (4 3/4inches), select "SMALL."
• Ifyouhaveselected"NO"forthesubwoofersetting, youcanonly
select "LARGE" for the front speaker setting,
• Ifyouhaveselected"SMALL"forthefrontspeakersetting, you
cannot select "LARGE" for the center and rear speaker settings,
3 Press SETTING repeatedly until ......
"FRNT DIS (Front distance)" "CNTR _'x_'_
DIS (Center distance)," or "REAR DIS
(Rear distance)" (with the current setting)*
appears on the display.
• The display shows the current setting in the unit selected in
step 2.
* "3.Ore" is the initial selling for meier and "lOFT" is for feet. If
you have already changed the setting, another value will be
shown.
4 Press CONTROL UP A/DOWN • oo_"%
to select the appropriate speaker
distance.
• If you have selecled "METER" in step 2, the
value is changed fiom "0.3m" to "9.0m" by 0.3 m slep.
• If you have selected "FEEl"' in step 2, the value is changed
from "1FI" to "30FT" by I foot step.
Example: In this case,
set "FRNT DIS" to "3.0m" or "10FT,"
set "CNTR DIS" to "2.7m" or "9FT" and,
set "REAR DIS" to "2.4m" or "8FT."
Note:
1
If you have selected "NONE" for the center and rear speakers
setting, you cannot set the speaker distance for the center and rear
speakers,
13