Manual

Remote Control
/
g
o
€
€
E
Once each of tbllowing settings has been adjusted, this receiver
memorizes the adjustments tbr each source.
When the input level of the analog source is too high, sounds will
be distor/ed. If this happens, you need to attenuate the input signal
level to prevent the sound distortion.
1 Press and hold INPUT ATT (INPUT _'_' ......
ANALOG) so that the INPUT ATT ,_,_A-'-Q/2
indicator lights up on the display.
• Each time you press and hold the bullon, the lnput Attenuator
mode turns oil ("INPUT ATT ON") or off ("INPUT
NORMAL").
Note:
' ._.i'rJt_ l_ _ _-_]!l,'_17FTJIt_JI ,Tft_ ,I!T41_ IWhen selecting "DVD MULTI" as the source, this effect does not work.
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speaker output balance.
Betbre you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step I again.
1 Press ADJUST repeatedly until .....
"BALANCE" (with the current setting)* _=_'x_
appears on the display.
*"CNTR (Center)" is the initial setting. If you have already
changed the setting, another setting will be shown.
Press CONTROL UP A/DOWN • .......
t_o_ up
to adjust the balance.
• Pressing CONTROL UP • decreases the
left channel output from "CNTR (Center)"
to "L 21."
• Pressing CONTROL DOWN • decreases
the right channel output from "CNTR (Center)" to "R 21 ?'
You can adjust the bass and treble sounds as you like.
Betbre you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step I again.
1 Press ADJUST repeatedly until "BASS" .....
or "TREBLE" (with the current setting)*
appears on the display.
*"0" is the initial setting. If you have already changed the
setting, another number (level) will be shown.
TREBLE : '11) adjust the treble ( I0 to +10).
Press CONTROL UP A/DOWN • to oo_&'_"%
adjust the bass or treble sound level.
• Each time you press the button, the sound _'X<'xp
level changes by ±2 steps.
You can adjust the subwoofer output level if you have connected a
subwoofer and set the subwoofer infer nation correctly 'YES?'
Onthe front panel:
Befbre you start, rememher...
'Ihere is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step I again.
1 Press ADJUST repeatedly until ......
"SUBWFR (Subwoofer)" (with the
current setting)* appears on the display.
* "0" is the initial selling. If you have ah-eady changed the
setting, another number (level) will be shown.
Press CONTROL UP A/DOWN • to o_'_°%
adjust the subwoofer output level
(-10 to +10). 'x_'>
Fromtheremotecontrol:
1 Press SOUND.
l0 keys are activated for sound adjustments.
Press SUBWOOFER +/- to adjust -_woo_+
the subwoofer output level _ @
(-10 to +10).
Note:
Subwoofer output level cannot be adjusted when using headphones.
15