Manual

Before you start, remember...
• Make sure that you have set the speaker inibrmation correctly (see pages 12 to 14).
• You cannot adjust the center speaker output level when you have set "CNTR SP" to "NONE."
• You cannot adjust the rear speaker output levels when you have set "REAR SP" to "NONE."
• Remember not to change the speaker setting while using any Surround mode; otherwise, it may be canceled when you deactivate the
speakers required for Surround mode.
Front Panel
Jvc
.......
I I
==== I ......... 1
[ ° -- ° ,1
/
O/J
O
o
€
i#1
Once you have adjusted the Surround modes, the adjustment is
memorized for each source.
• When playing back digital multichannel software (Dolby Digital
5.1 ch or DTS Digital Surround), the SURROUND MODE button
does not work.
Fromthe remotecontrol:
It will be convenient for you to use the remote control for
adjustments, since you can make adjustments from your listening
point by using the lest signal.
• For selecting Panorama control for Pro Logic 11 Music, use the
buttons on the front panel.
Set the analog or digital input mode for the source
you like to listen and start playing.
When playing back software encoded with Dolby Digital and
DTS Digital Surround, select the digital input mode (see page
ll).
Press SURROUND ON/OFF to
activate Surround mode.
Each time you press the button, Surround mode
turns on and off alternately.
• If you are playing back software encoded with Dolby Digital
multichannel, "DOLBY DIGITAL" is selected.
• If you are playing back software encoded with DTS Digital
Surround, "DTS SURROUND" is selected.
• If you are playing back any software other SURROUND
than above, you can select "PL 11MUSIC" or
"PL II MOVIE" according to the source by
pressing SURROUND MODE (['113PRO LOGIC II
indicator lights up on the display0
If you like to adjust sound, go to step 3.
TO BE CONTINUED ON THE NEXT PAGE 21