Manual

The AV COMPU LINK remote control system allows you to operate JVC's audio components through the remole sensor on the receiver.

To use this remote control system, you need to connect the video components you want to operate by following the diagram and the

procedure below.

• Make sure that AC power coMs of these components are unplugged before connecting. Plug AC power coMs only after all connections are

completed.

CONNECTIONS:

VCR DVD player TV

_*,,,,_I_ _

Note:

You can only connect to the TV with the AV COMPU LINK EX or AV

COMPU LINK II! terminal

The TV with AV COMPU LINK RECEIVER/AMP terminal will not be

used.

Notes:

• When connecting only the VCR and DVD playerto this receiver, use the cable with monaural mini-plugs.

• YoucanconnectonlytheTVwithAVCOMPULINKtotheAVCOMPULINKterminaL

• Referalso to the manuals supplied with your video components.

• Make sure that the remote contro! code of the VCR connected to the VCRjacks is set to code "A."

1 Unplug your VCR, DVD player, TV, and this

receiver from the AC outlets.

2 Connect your VCR, DVD player, T¥, and this

receiver using cables with the monaural mini-

plugs (not supplied).

• See "CONNECTIONS" above.

,3 Connect VCR, DVD player, T¥, and this receiver

using cables with RCA pin plug.

• See pages 6 and 7.

4 Plug AC power cords of the components back into

the AC outlets.

5 When turning on the TV for the first time after

the AV COMPU LINK connection, turn the TV

volume to the minimum with the volume control

on the TV.

6 Turn on the other connected components first,

then turn on this receiver.

• When turning oil theVCR, use the remote control supplied

with this receiver (press STANDBY/ON ell VCR).