Manual

Use this chart to help you solving daily opera/ional problems. If there is any problem you cannot solve, contact your JVC service center.
The power does not turn on. The power cord is not plugged in. Plug the power cord into an AC outlet.
The SPEAKERS ON/OFF button is not Press SPEAKERS ON/OFF button correctly.
set correctly.
iiiiii! ii! ! i !!!!!!!i ii i i i i iiiiii iii
Muting is activated. Press MUTING to cancel the mute.
Connections are incorrect. Check connections.
For analog connections, see page 6.
For digital connections, see page 7.
The balance is set to one extren/e.
Adjust the balance properly (see page 15).
The station is too far away. Select a new station.
o
Antennas are not connected properly. Check connections.
"OVERLOAD" starts flashing on the
display.
Speakers are overloaded because of high
volume.
I. Press STANDBY/ON Oil on tile I?ont
panel to turn off the receiver.
2. Stop the playback source.
3. Turn on the receiver again, and adjust the
volunle.
"DSP MICON NG" starts flashing on the The built-in microcomputer is not Press STANDBY/ON Oil on the front panel to
display, functioning correctly, turn oft-_he receiver. After unplugging the
power cord, consult your dealer.
Remote control does not work. There is an obswuction in l?ont of tile
renloto sensor on the receiver.
Remove the obstruction.
Remote control does not work for the
source (or other components) you _ry to
operate.
An incorrect remote control operation
mode is selected.
Select tile correct remote control operation
mode (see pages 28 and 29).
3O