Manual

General Precautions
• DO NOT insert any metal o_ect to the unit.
• DO NOT disassemble the unit or remove screws, covers, or
cabinet.
• DO NOT expose the unit to rain or moisture.
Locations
• Install the unit in a location that is level and prolected fl-om
moisture.
• The lemperature around the unit must be between 5°C and 35_'C
(23°F and 95°F).
• Make sure there is good ventilation around the unit. Poor
ventila/ion could cause overhea/ing and damage the unit.
Handling the unit
• DO NOT touch the power co_ with wet hands.
• DO NOT pull the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to damage
the cord.
• Keep the power cord away fiom the connecting cords and the
anlenna. The power cord may cause noise or screen interference. It
is recommended to use a coaxial cable for anlenna connection,
since it is well-shielded against interference.
• When a power failure occurs, or when you unplug the power cord,
the preset sellings such as preset FM/AM channels and sound
ac[justments may be erased in a few days.
Before using the remote control, put two supplied batteries first.
• When using the remole control, aim the remote control directly at
the remote sensor on the unit.
I On the back of the remote control, remove the
battery cover.
2 Insert batteries.
• Make sure to match the polarity: (+) to (+) anti (-) to (-).
/
1U
_t
¢D
=_
5"
gl
gl
€,Q
O't
[_,"t_ITT_ l _,"t_-T!l,j :1i_, F:_
Check to be sure you have all of the following supplied accessories.
The number in the parentheses indicales the quantity of the piece(s)
supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
If anything is missing, contact your dealer immediately.
3 Replace the cover.
If the range or effectiveness of the remote control decreases, replace
the batteries. Use two R6P(SUM-3)/AA(15F) type dry-cell batteries.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:
(+) to (+) and (-) to (-).
• Use the correct type of batteries. Batteries that look similar may
differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
3