Manual

DVDplayer I
[_ DVD player
OUT
FRO_T
IMPORTANT:
• When connecting the DVD player or digital TV to the digital terminal,
you also need to connect it to the video jack on the rear. Without S"
connecting it to the video jack, you cannot view any playback t,a
picture.
• After connecting the components to the DIGITAL IN terminals, make
sure the following if necessary: _..
- Set the digital input terminal setting correctly. For details, see
"Setting the Digital Input (DIGITAL IN) Terminals" on page 11.
- Select the digital input mode correctIy. For details, see "Selecting
the Analog or Digital Input Mode" on page 11.
Digital TV
CD player
DVDplayer
/
SUBWOOF£R
OUl
iA] To front left/right channel audio output (or to audio mixed
output)
To video output
Note:
TOenjoy the software encoded with Dolby Digital or DTS Digital
Surround, you must connect the DVD player using the digital terminal
on the rear of this receive_ (See "Digital connections" below.)
For enjoying DVD MULTI Playback Mode-
. When you connect the DVD player with its analog discrete output
(5.1 CH reproduction)jacks:
[_[_ DVD player
CD recorder
When the component has a digital coaxial
output terminal, connect it to the DIGITAL
1 (DVD) terminal, with the digital coaxial
cable (not supplied).
When the component has a digital optical
output terminal, connect it to the DIGITAL
2 (CD) terminal, with the digital optical
cable (not supplied).
Before connecting a digital
optical cable, unplug the _._<J
protective plug.
IV
SEll]WOOFER
ou1
IA, To rear left/right channel audio output
To center channel audio output
To subwoofer audio output
To front left/right channel audio output
To video output
}CR
IN
(PLAY)
Digital connections
This receiver is equipped with two DIGITAL IN terminals--one
digital coaxial ierminal and one digital optical terminal.
You can connect any component to one of the digital terminals using
a digital coaxial cable (not supplied) or digital optical cable (not
supplied).
Notes:
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components:
- DIGITAL 1 (coaxial): For DVD player
- DIGITAL 2 (optical): For CD player
• When you want to operate the CD player or CD recorder using the
COMPU LINK remote contro! system, connect the target
component also as described in "Analog connections" (see page 6).
Before plugging the power cord into an AC outlet, make sure that all
connections have been made.
Plug the power cord into an AC outlet.
CAUTIONS:
• Do not touch the power cord with wet hands.
• D° n°t pull °n the p°wer c°rd t° unplug the c°rd When
unplugging the cord, always grasp the plug so as not to damage
the cord.
7