User Manual

Operation Instructions

⑴ SOURCE: Input signal source selection

F1 – F4: User definable function keys

User can set F1, F2, F3, F4 keys to corresponding function for quick operation. For details

please refer to “Sub Menu - 4.Function key”.

When user press and hold the function keys for more than 3 seconds, it will pop-up a definable

function list menu, user can rotate and press to select functions. If no operation exceeds 3

seconds, the monitor will automatically save the selection and Exit.

DISPLAY: OSD info on/off

Press “DISPLAY” to turn on or turn off relevant status information, audio and video scopes.

⑵ Menu Knob

 Main menu settings

Press the Menu knob to open the menu system on the left top of the screen;

Rotate the knob up and down to select menu items and press the knob to enter or confirm.

 Adjust volume, image display parameters

Out of menu system, directly rotate the knob to adjust volume. Press the menu knob to apply the

adjusted volume value, and turn to brightness, contrast, saturation in turn.

Note: The last adjusted item will be memorized in system, and when next time directly revolve the

Menu Knob, it will adjust the last item.

⑶ SPEAKER: SDI/HDMI audio and analog audio output (will not work if headphone is connected)

⑷ POWER: Switch on/off the power

⑸ DC IN: 4-pin XLR DC input, 6.5-36V, (Pin 1: Negative, Pin 4: Positive)

⑹ Battery plate installation area

⑺ GPI: GPI control input (RJ45), refer pin description to “Main Menu – 5. GPI”

⑻ SDI-IN1: 2K/3G/HD/SD SDI input (BNC)

SDI-IN2: 2K/3G/HD/SD SDI input (BNC)

SDI OUT: When current display signal is SDI1, it will loop through output SDI1 signal;

When current display signal is SDI2, it will loop through output SDI2 signal;

When current display signal is HDMI, it will convert HDMI to SDI output;

* The HDMI to SDI conversion doesn’t support SD signal.

HDMI-IN: HDMI 1.3 input (HDMI-A type)

HDMI-OUT: HDMI 1.3 loop through output (HDMI-A type)

CVBS-IN: PAL/NTSC composite video input (BNC)

⑼ USB: Connect external storage device, for firmware upgrades.

⑽ AUDIO-IN: Analog audio input (3.5mm)

AUDIO-OUT: Analog audio output (3.5mm)

⑾ TALLY light: Display Red/Green/Yellow TALLY signals; refer settings to “Main Menu – 5. GPI”