User Manual

8
Introduction of audio and video functions
 16-ch embedded audio meters
The monitor can display max 16 channels audio meters for SDI embedded audio, max 8 channels
meters for HDMI embedded audio, and 2 channels meters for analog audio. The audio meter is
green, and will turn yellow when audio exceeds -20dB, and turn red when audio exceeds -9dB.
 Audio alarm
If the embedded audio value is too low or no embedded audio, it will display “MUTE” or
“UNLOCKED” in the audio bar.
 Timecode (SDI)
Under SDI input, it can display the SMPTE timecode (VITC1, VITC2 or LTC) on the top of the
screen. If no Timecode information is detected, it will be displayed as “UNLOCKED”.
 Waveform (Y, Cb, Cr, R, G, B and single line)
Under SDI and HDMI input, Y, Cb, Cr, R, G, B and single line waveforms can be selected to
display
 Vector
The displayed vector scope pattern is available under both SDI and HDMI, represents saturation
as distance from the center of the circle, and hue as the angle, in standard position, around it.
 Histogram (R, G, B, W)
The histogram is a bar graph that shows the distribution of luminance values in the picture.
There’re R, G, B, W histograms that individually displayed simultaneously, available under both
SDI and HDMI.
 Internal Color Bar
Under SDI and HDMI input, it has 100% internal color bar which helps to analyze the monitor color
and adjust the display parameter.
 Peaking focus assist (red/blue switch)
The Peaking focus assist function is to mark the sharpest edges of the image with red or blue
color under SDI and HDMI input, for users to check if the subjects are focused.
 Zebra stripes
Zebra Stripes are used to check if the image is over exposed or not by showing black and white
lines on the monitor. It is considered over exposed when luminance value exceeds 90%.
 Freeze Frame
The freeze frame is to capture and display the current broadcast frame.
 R/G/B/Mono
R/G/B/Mono is to display only the blue/red/green primary signal or the luminance signal only so as
to monitor the image noise.
 False Color
The false color is used to aid in the setting of camera exposure. Under false color mode, there’s a
color chart on the bottom of screen for reference. The color from the dark to the bright will be
displayed as blue, cyan, green, yellow, orange and red in a consecutive way.
 AFD (SDI)
It is the abbreviation of active format description. AFD is to display the SDI embedded AFD
information graphically on the screen.
 H/V Delay (SDI)
Under SDI input, H/V Delay can be used to display line/field blanking signal, and to observe the
horizontal and vertical synchronous signal.
 Flip and Rotate
The image can be set up/down flip, or left/right mirror display, like:
Normal Left to right Up to down 180° Rotate