Operation Manual

30 EN
Master Page: Left
To Print By Selecting Still Images And Number
Of Prints
1
Perform steps 1 – 8 in “To Print All Still Images
(One Print For Each)” (墌 pg. 29).
2 Press + or – to select
“CURRENT”, and press
SET/SELECT. The DPOF
screen appears.
3 Turn the SHUTTLE
SEARCH Ring to the left
(3) or to the right (5)
to select the desired file.
4 Press + or – to select the number indication (00),
and press SET/SELECT.
5 Select the number of prints
by pressing + to increase
the number, or – to
decrease the number, and
press SET/SELECT.
● Repeat steps 3 through 5
for the desired number
of prints.
● The number of prints can be set up to 15.
● To correct the number of prints, select the
image again and change the number.
6 Press + or – to select
“RETURN”, and press SET/
SELECT. The “SAVE?”
appears.
● If you did not change
any settings in step 3
through 5, the Menu
Screen reappears.
7 Press + or – to select “EXECUTE” to save the
setting you have just made, and press SET/
SELECT.
● To cancel selection, select “CANCEL”.
To Reset The Number Of Prints
1
Perform steps 1 – 8 in “To Print All Still Images
(One Print For Each)” (墌 pg. 29).
2 Press + or – to select “RESET”, and press SET/
SELECT. The DPOF screen appears.
3 Press + or – to select “EXECUTE”, and press SET/
SELECT. The normal playback screen appears.
● To cancel selection, select “RETURN”.
● The number of prints is reset to 0 for all still
images.
You can initialise a memory card anytime.
After initialising, all files and data stored in the
memory card, including those which have been
protected, are cleared.
1 Set the VIDEO/MEMORY Switch to “MEMORY”.
2 Set the Power Switch to “P” while pressing
down the Lock Button located on the switch.
3 Open the LCD monitor fully, or pull out the
viewfinder fully.
4 Press MENU. The Menu
Screen appears.
5 Press + or – to select
“FORMAT”, and press
SET/SELECT. The FORMAT
screen appears.
6 Press + or – to select
“EXECUTE”, and press
SET/SELECT. The memory
card is initialised.
● When initialisation is finished, “NO IMAGES
STORED”, “NO E-MAIL CLIP STORED” or
“NO SOUND STORED” appears.
● To cancel initialisation, select “RETURN”.
CAUTION:
While performing the above, never disconnect
power, as this may cause the memory card to be
corrupted.
RETURN
SHEETS
DPOF
00
SHEETS
DPOF
05
DPOF
EXECUTE
SAVE?
CANCE L
Initialising A Memory Card
CAUTION:
Do not perform any other operation (such as
turning off the camcorder) during initialisation.
Also, be sure to use the provided AC Power
Adapter/Charger, as the memory card may be
corrupted if the battery becomes exhausted during
initialisation. If the memory card becomes
corrupted initialise it.
MENU
DISPLAY
END
PROTECT
DELETE
DPOF
NO . RES E T
FORMAT
ORMA TF
EXECUTE
DATA?EX I ST I NG
ERASE ALL
RETURN
D.S.C. PLAYBACK (cont.)
GR-DVP9-8PAL.book Page 30 Friday, February 7, 2003 12:35 PM