User's Manual
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Adjusting the White Balance
- Adjusting the Camera Image
- Audio Recording
- Audio Output during Recording
- Time Code and User’s Bit
- Setting Time Code Generator
- Setting the User’s Bit
- Synchronizing the Time Code with an External Time Code Generator
- Setting Zebra Pattern
- Setting Spot Meter
- Acquiring Positioning Information by GPS
- Viewing Recorded Videos Immediately (Clip Review)
- Displaying the Video Signal Monitor
- Recording Simultaneously at Two Different Definitions
- Series Rec
- Dual Rec
- Backup Rec
- Special Recording
- Splitting the Clips Freely (Clip Cutter Trig)
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Connecting to the Network
- Functions of Network Connection
- Preparing Network Connection
- Importing Metadata
- Uploading a Recorded Video Clip
- FTP Resume Feature
- Connecting from a Web Browser
- Editing Metadata
- Uploading a Recording Clip via a Web Browser
- View Remote Control and Camera Control Functions
- Changing the Settings via a Web Browser
- Managing the Network Connection Settings File
- Performing Live Streaming
- Return Video/Audio from the Network (Return over IP)
- IFB (Return Audio)
- Others
Attaching/Detaching the Battery (E Model)
Use the following battery type.
0
V Mount
1
Attach the battery.
Face the terminal downward and attach the V
mount of the battery onto the V mount
attachment bracket of the camera recorder.
2
Press down the battery until it snaps into
place.
.
V Mount
V Mount
Attachment Bracket
3
Detaching the Battery
Press down the release lever and slide the
battery upward to detach it from the camera
recorder.
.
Battery
Release Button
Precautions for Batteries
0
Store the battery in a cool and dry place when
not in use. Do not expose the battery to high
temperatures (such as in a car under direct
sunlight). This will cause battery leakage and
shorten the battery life.
0
Operating time is shortened if the battery
terminal is dirty.
0
If the operating time shortens drastically even
after charging, the battery may be reaching the
end of its life. Replace the battery with a new
one.
Battery Warning Settings
Follow the steps below to configure the warning
voltage or warning level when the remaining
battery level is running low.
1
Select “Voltage” or “Capacity%” in
[System] B [Battery] B [Type
]
0
“Near End (V)
”
and “End (V)” are enabled
when “Voltage” is selected.
0
“
Near End (%)” and “End (%)” are enabled
when “Capacity%
” is selected.
2
Configure “Near End” and “End”
0
Configures the setting at which the power is
shut down automatically after the warning is
activated.
(A P149
[ Near End (V) 0 ] )
(
A P149 [ End (V) 0 ] )
(A P149 [ Near End (%) 2 ] )
(A P149 [ End (%) 2 ] )
3
Check in advance to ensure that the
connected battery is in order and the
settings are appropriate
0
If the time is different from what has been
anticipated, repeat the steps in 2 and 3.
Memo :
0
When the battery that is connected does not
support communication, “Near End (V)” and
“End (%)” are enabled even when
“Capacity%”
is selected.
Power Supply
35
Preparations