INSTRUCTIONS
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Adjusting the White Balance
- Adjusting the Camera Image
- Audio Recording
- Audio Output during Recording
- Time Code and User’s Bit
- Setting Time Code Generator
- Setting the User’s Bit
- Synchronizing the Time Code with an External Time Code Generator
- Setting Zebra Pattern
- Setting Spot Meter
- Acquiring Positioning Information by GPS
- Viewing Recorded Videos Immediately (Clip Review)
- Displaying the Video Signal Monitor
- Recording Simultaneously at Two Different Definitions
- Series Rec
- Dual Rec
- Backup Rec
- Special Recording
- Splitting the Clips Freely (Clip Cutter Trig)
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Connecting to the Network
- Functions of Network Connection
- Preparing Network Connection
- Importing Metadata
- Uploading a Recorded Video Clip
- FTP Resume Feature
- Connecting from a Web Browser
- Editing Metadata
- Uploading a Recording Clip via a Web Browser
- View Remote Control and Camera Control Functions
- Changing the Settings via a Web Browser
- Managing the Network Connection Settings File
- Performing Live Streaming
- Return Video/Audio from the Network (Return over IP)
- IFB (Return Audio)
- Others
Error Messages and Actions
Warning display
on the LCD monitor and viewfinder screen, tally lamp indication and warning tone are as
follows according to the error status.
Memo :
0
This camera recorder makes use of a microcomputer. Noise interference from external sources may
prevent it
from functioning properly. When this occurs, turn off and on the power of the camera recorder
again.
Error Message Status Action
Turn Power Off Turn Back On
Later
System error.
* The warning
tone sounds and the
tally lamp blinks twice every
second.
Turn off the power, and turn it on
again.
If the error persists, please contact
the local dealers in your area.
Fan Stop Detected Please
Turn P.Off
0
The fan stopped running. Please contact the local dealers in
your area.
Fan Maintenance Required Usage time of the fan has exceeded
9000 hours.
Check the fan and replace
accordingly. For more details,
please contact the local dealers in
your area.
Memo :
0
You can
check the usage time of
the fan in [System] B [System
Information] B [Fan Hour].
(A P
150 [ Fan Hour ] )
Getting Overheated. Please
Turn Power Off.
0
The battery has exceeded the
specified temperature.
0
The power turns off
automatically after about 15
second.
0
Wait until the temperature drops
or replace the battery.
0
If the error persists, please
contact the local dealers in your
area.
Rec Inhibited [REC] button is pressed when the
write-protect switch of the SD card
is set.
Turn off the write-protect switch of
the SD card, or insert a recordable
SD card.
(A P
47 [SD Card] )
Lost Media Info *
0
Card
is
removed while recording
is in progress.
0
Card is removed while
formatting is in progress.
0
Card is removed while restoring
is in progress.
0
Card is removed while adding
the OK mark.
0
Card is removed while writing a
setup file.
0
Card is removed while deleting a
clip.
(*: A, B)
Restore the card using this camera
recorder.
(A P51 [Restoring the SD Card] )
218
Error Messages and Actions
Others