User's Manual
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Adjusting the White Balance
- Adjusting the Camera Image
- Audio Recording
- Audio Output during Recording
- Time Code and User’s Bit
- Setting Time Code Generator
- Setting the User’s Bit
- Synchronizing the Time Code with an External Time Code Generator
- Setting Zebra Pattern
- Setting Spot Meter
- Acquiring Positioning Information by GPS
- Viewing Recorded Videos Immediately (Clip Review)
- Displaying the Video Signal Monitor
- Recording Simultaneously at Two Different Definitions
- Series Rec
- Dual Rec
- Backup Rec
- Special Recording
- Splitting the Clips Freely (Clip Cutter Trig)
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Connecting to the Network
- Functions of Network Connection
- Preparing Network Connection
- Importing Metadata
- Uploading a Recorded Video Clip
- FTP Resume Feature
- Connecting from a Web Browser
- Editing Metadata
- Uploading a Recording Clip via a Web Browser
- View Remote Control and Camera Control Functions
- Changing the Settings via a Web Browser
- Managing the Network Connection Settings File
- Performing Live Streaming
- Return Video/Audio from the Network (Return over IP)
- IFB (Return Audio)
- Others
Connecting to Network via Built-in
Wireless LAN u v 0
1
Configure the connection settings with
[Wizard].
0
Select “USB/Int. WLAN”
in [Network] B
[Connection Setup] B [Wizard], and
configure the settings according to the
instructions on the screen.
Perform setting for the following.
0
Mode of connection
0
Configuration method
* For P2P connections, it is necessary to
configure the [Default Gateway] and
[Passphrase
] according to the steps below
after the above settings are configured.
A
Set
[Network
] B [Connection Setup] B
[Default Gateway] to “USB/Int. WLAN”.
B
Set the camera recorder to the Camera
mode, and display the [USB/Int. WLAN]
(status) screen.
0
Press the [STATUS/SET] button on the
camera recorder to display the status
screen. Press the cross-shaped button
(
H I) to display the [USB/Int. WLAN]
screen.
0
Check to ensure that the [
SSID
] and
[Passphrase] that you have set in the
wizard are displayed.
C
Select an SSID from the list of access
points (smartphone, tablet terminal, PC,
etc.) and enter a passphrase.
0
Display the list of access points in the
wireless connection settings of the
smartphone, tablet terminal, or PC, and
select “HC900-****
”. (**** are numbers
that vary with the device used.)
0
After the password confirmation screen
appears, enter the [
Passphrase]
displayed on the [USB/Int. WLAN]
screen.
2
Setting is complete.
After setting is complete, you can access the
camera recorder via a web browser.
Memo :
0
After setting
is complete, the following items will
be automatically configured.
0
The [Network] B [Connection Setup] B [USB/
Int. WLAN] setting changes to “On”.
0
The [Network] B [
Connection Setup]
B
[Default Gateway] setting changes to “USB/
Int. WLAN”. However, this does not apply to
the P2P connection.
0
The
[Network]
B [Live Streaming] B
[Interface] setting changes to “USB/Int.
WLAN”.
188
Preparing Network Connection
Connecting to the Network