User's Manual

Symptom Action
The [CH-1/CH-2] recording
level adjustment knob does
not work.
0
Is
the
[AUDIO SELECT CH1/2]-[MANUAL/AUTO] selection switch set
to “AUTO”?
0
Is Full Auto enabled?
Is
[Camera Function
] B [Full Auto] B [Audio] set to “Auto” in Full Auto
mode?
(A P115 [Full Auto Item] )
[
CH-3/CH-4] audio is not
recorded.
0
Is the number of recording channels set to
“4ch
”?
Set [System] B [Record Set] B [WAudio]/[YAudio] to “4ch”.
(A P153
[ W Audio ] )
Microphone audio cannot be
heard
through
the headphone.
0
Is the audio setting configured to “IFB/RET Only”?
Set [A/V Set] B [Audio Set] B [IFB/RET Monitor] to “Off”.
(A P138
[ IFB/RET Monitor... 0
] )
SD card cannot be initialized
(formatted).
0
Is the write-protect switch of the SD card turned on?
Make sure that the write-protect switch is turned off.
(A P48 [Write-Protect Switch on the SD Card] )
Battery alarm appears even
after loading a charged
battery.
0
Is the battery too old?
The time code and user’s bit
are not displayed.
0
Even in Camera mode or Media mode, the time code and user’s bit
may not be displayed depending to the type of display.
0
Is
[LCD/VF]
B [Display On/Off] B [TC/UB] set to “Off”? To display the
date and time, set it to “On”.
(A P
130 [Display On/Off Item] )
The time is not displayed.
0
The
time
is only displayed on the display screen in the Camera mode
(during shooting).
(A P161 [Display Screen in Camera Mode] )
0
Is [System] B [Record Set] B [Time Stamp] set to “On”? To display
the date and time, set it to “Off”.
(A P
156 [ Time Stamp ] )
The actual recording time is
shorter than the estimated
time.
0
The recordable time may be shorter depending on the shooting
conditions or the subject.
The two camera recorders are
not synchronized even though
the time codes have been
synchronized. (Z
on the Slave
device is not displayed.)
0
Is the
[TC GEN] switch set to “F-RUN”?
(A P78 [Synchronizing the Time Code with an External Time Code
Generator] )
0
Set [System]
B [Record Set] B [Record Format] B [WFrame Rate]
such that the two camera recorders have the same frame rate.
(A P152 [ W Frame Rate ] )
Cannot connect to wireless
LAN.
0
Check the mode of connection and method of setting (
[SSID] and
[Passphrase] in cases other than WPS).
(
A
P187 [Connecting to Network via [HOST] Terminal (USB) 0
] )
(A P188 [Connecting to Network via Built-in Wireless LAN u v
0] )
0
Even if the Passphrase is wrong, “Completed the Setup Wizard.
Please Input the Passphrase into Your Device.
” may appear at the
browser setting depending on the type of encryption.
Adjust [Passphrase] again.
0
Set [Network] B [Connection Setup] B [Default Gateway
] to a value
other than “LAN”.
(
A P
140 [ Default Gateway ] )
224
Troubleshooting
Others