INSTRUCTIONS

Attaching the Anti-reflective Film
Attach the supplied anti-reflective film onto the LCD
monitor if necessary, such as when you are
recording in the day or outdoors.
Doing so helps to cut down reflection of outside
light, thus improving the visibility.
1
Wipe off any dirt, dust or stains on the
surface of the LCD monitor.
2
Peel off the backing of the anti-reflective
film halfway.
Pay attention to prevent fingerprints from being
left on the adhesive face.
3
Attaching the Anti-reflective Film
0
Align
and
paste
the anti-reflection film on the
LCD monitor screen without trapping any air
bubbles.
0
Squeeze the air bubbles out.
0
You may repaste the anti-reflection film if air
bubbles are accidentally trapped.
Memo :
0
Do not press the LCD monitor surface with
excessive force when attaching the film.
0
For additional orders of the anti-reflective film,
please
consult
the
authorized dealer from which
this camera recorder was purchased, or our
service center.
Attaching the Tripod
Use the screw hole at the bottom of this camera
recorder.
(1/4×20UNC)
Use the screw hole that suits the tripod.
To prevent the camera recorder from falling off,
which may result in injuries or damages, read the
“INSTRUCTIONS” of the tripod to be used and
make sure that it is securely attached.
.
o Bottom
Caution :
0
If the camera recorder exceeds the weight limit
of the tripod, do not mount it on the tripod.
0
Use the tripod on a stable surface.
0
To prevent the camera recorder from falling,
attach securely using the rotation prevention
hole.
0
Use screws with
screw length 5 mm and below.
Settings and Adjustments Before Use
31
Preparations