INSTRUCTIONS(BASIC)

Attaching the Handle Unit
The handle unit is detached from the camera
recorder unit in the factory shipment.
To use the handle unit, attach it by following the
steps below.
* Attach
or detach the handle unit when the power
is turned off.
.
1
Fit the handle terminal at the bottom of the
handle unit to the handle unit mount at the
top of the camera recorder.
0
Fit the handle unit carefully, paying attention
not to damage the terminals at the bottom of
the unit.
2
Slide the handle unit in the direction
indicated
by
the arrow to attach it to the hot
shoe of the camera recorder.
3
Press the screw on the handle unit and turn
it in the clockwise direction. Tighten it
securely to fasten the unit to the camera
recorder.
0
The handle
unit may be unsteady if the screw
is not securely fastened, and may fall off
during use.
Caution :
0
Attach or
detach the handle unit when the power
is turned off.
Doing so when the power is turned on can result
in malfunction.
Adjusting the Grip Belt
Open the
pad and adjust the position of the grip belt
accordingly.
.
Caution :
0
If the
grip is loose, the camera recorder may fall
off resulting in injuries or malfunction.
Charging the Battery
Charging the Battery
Charge the battery immediately after purchase or
when the battery power is running low.
* The battery is not charged when purchased.
.
3
2
1
4
14
Attaching the Handle Unit
Preparations