INSTRUCTIONS(BASIC)

Loading Clips to the PC
0
You can load clips to a PC by connecting the
camera recorder to the PC via the USB port.
Doing so enables clips stored in the SD card to
be managed and edited on the PC.
0
Files
on
the SD card can be managed/edited on
the connected PC in this mode only for USB
mass storage class devices that are recognized
by the said PC as a peripheral drive.
Memo :
0
Files cannot be written to the SD card.
1
Connect the camera recorder to the PC
using a USB cable.
A confirmation message “Change to USB
Mode?” to
enable the USB connection appears.
.
PC
2
Select [Change] using the cross-shaped
button (JK), and press the Set button (R).
The camera recorder switches to USB mode.
.
2
Cancel
Change
Change to USB Mode?
Memo :
0
If recording is in progress, the “Change to USB
Mode?” message appears after recording
stops.
0
If playback is in progress, the camera recorder
switches to USB mode after the file closes
automatically, such as when playback stops.
Disconnecting
0
Disable the
connection on the PC, then remove
the USB cable from the camera recorder.
0
Doing so exits the USB mode and switches the
camera recorder to Camera mode.
Memo :
0
The procedure
for disabling the USB connection
varies according to the PC in use. For details,
refer to the “INSTRUCTIONS” of the PC.
Loading Clips to the PC
25
Connecting External Devices