INSTRUCTIONS
Table Of Contents
- Introduction
- Preparations
- Shooting
- Basic Shooting Procedures
- Selecting System Definition, File Format and Video Format
- Zoom Operation
- Focus Operation
- Adjusting the Focusing by Face Detection
- Adjusting the Brightness
- Adjusting the Iris
- Setting the Gain
- Setting the Electronic Shutter
- Setting the ND Filter
- Adjusting the White Balance
- Adjusting the Camera Image
- Using the Image Stabilizer
- Audio Recording
- Monitoring Audio Sound During Recording Using a Headphone
- Time Code and User’s Bit
- Setting Time Code Generator
- Setting the User’s Bit
- Setting Zebra Pattern
- Viewing Recorded Videos Immediately (Clip Review)
- Using the Histogram
- Recording Simultaneously at Two Different Definitions
- Series Rec
- Dual Rec
- Backup Rec
- Special Recording
- Splitting the Clips Freely (Clip Cutter Trig)
- Playback
- Menu Display and Detailed Settings
- Display/Status Screen
- Camera Features
- Connecting External Devices
- Connecting to the Network
- Functions of Network Connection
- Preparing Network Connection
- Importing Metadata
- Uploading a Recorded Video Clip
- FTP Resume Feature
- Connecting from a Web Browser
- Editing Metadata
- Uploading a Recording Clip via a Web Browser
- View Remote Feature
- Camera Control Function
- Configuring Settings via a Browser
- Managing the Network Connection Settings File
- Performing Live Streaming
- Broadcast Overlay
- Others
One Push Auto Iris
When [One Push Iris] is assigned to the user
button, press
this button in the Manual Iris mode to
adjust the iris according to the brightness of the
subject.
Push Auto Iris
When [One Push Iris] is assigned to the user
button, press and hold down this button in the
Manual Iris mode to change to the Auto Iris mode
temporarily. The iris will be automatically adjusted
according to the brightness of the subject.
About the Iris F-number
Blurry effects due to “small aperture diffraction”
may occur when the diameter of the iris becomes
too small. When this phenomenon occurs, the F-
number on the screen turns gray to warn you that
the diffraction F-number of the iris has been
exceeded.
You are
recommended to make appropriate use of
ND filters to prevent the F-number from turning
gray.
Setting the Gain
This
function
electrically boosts the light sensitivity
when there is insufficient illumination on the object.
You can set the gain of the video amplifier
according to the brightness of the object. Select the
setting mode according to your shooting
conditions.
.
Automatic Gain Mode (Automatic Gain
Adjustment)
1
Press and hold the [FULL AUTO] button to
set Full Auto mode to off.
2
Set [Camera Function] B [GAIN L]/[GAIN
M]
/[GAIN H] to “AGC”.
(A P
99 [GAIN L, GAIN M, GAIN H] )
If
an item specified with “AGC” is selected using
the [GAIN L/M/H] gain switch, the Auto Gain
Adjustment mode is enabled and the gain of the
video amplifier is automatically set according to
the brightness of the subject.
The sensitivity value (in dB) will not be displayed
in the Auto Gain mode.
Memo :
0
Pressing and holding the [FULL AUTO] button
to enter the Full Auto mode also activates the
Auto Gain mode. In this case, the Iris, Shutter
and White Balance also enter into Auto mode
forcibly.
0
The switching operation of the [GAIN L/M/H]
switch is disabled in the Full Auto mode.
0
The upper limit of the gain setting value during
AGC operation can be set in [Main Menu
] B
[Camera Function] B [AGC Limit].
(A P
99 [ AGC Limit ] )
Adjusting the Iris
57
Shooting