INSTRUCTIONS

Setting Time Code without Opening the
Menu
.
Memo :
0
Settings cannot
be made in the following cases.
0
[TC/UB] B [TC Generator] has been set to
“Regen”.
0
Menu screen is displayed.
0
The camera recorder is not in the Camera
mode.
Setting Time Code
1
Set [TC/UB] B [TC Generator
] to “Rec
Run” or “Free Run”.
(A P
106 [ TC Generator ] )
2
Press the
[TC/2] button.
The [TC Preset] setting screen appears.
.
TC Preset
During drop frame
During non-drop frame
Cursor
3
Set the time code (hour, minute, second,
frame).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
Memo :
0
Press the [C.REVIEW/4
] button to reset each
digit to “0”. The cursor moves to the time digit
(left).
4
Check the values and press the Set button
(R).
0
The time code is set and the screen returns
to the normal screen.
0
To cancel the setting, press the [CANCEL/
STOP
] button.
Caution :
0
When
the
camera recorder is switched to Media
mode during editing, editing will be canceled
and the screen will close.
0
When editing the time code, operation of the
buttons that are set in [Main Menu] B [Camera
Function] B [User Switch Set] is disabled.
[C.REVIEW/4] functions as the number reset
button.
(A
P100 [User Switch Set Item] )
Recording Time Code in Continuation of
the Recorded Time Code on SD Card
This camera recorder is equipped with the time
code reader.
1
Set [TC/UB] B [
TC Generator
] to “Regen”.
0
When the camera recorder enters from
recording standby mode to recording mode,
it reads the time code already recorded on
the SD card and records the new time code
in continuation of that value.
0
The same data as the user’s bit already
recorded on the SD card is recorded.
Memo :
0
When [TC/UB] B [TC Generator] is set to
“Regen”, the framing mode of the time code
follows the settings in
[TC/UB] B [Drop Frame]
instead of the clip settings.
(A P106
[ Drop Frame ] )
Setting Time Code Generator
71
Shooting