INSTRUCTIONS

Setting Zebra Pattern
When the luminance level range for displaying
zebra patterns is specified, diagonal lines (zebra
pattern) are displayed at areas with the specified
luminance levels during shooting.
.
1
Set the zebra display pattern.
Select the display pattern in [LCD/VF] B
[Shooting Assist] B [Zebra].
2
Specify the brightness (luminance) level
range for displaying zebra pattern.
Specify the upper and lower limits of the
luminance level in [LCD/VF]
B [Shooting
Assist] B [Zebra] B [Top] and [Bottom].
Item Settings Options
Top Upper luminance
limit for displaying
[Zebra]
5% - 100%, Over
(in 5 % increments)
Bottom Lower luminance
limit for displaying
[Zebra]
0% - 100% (in 5 %
increments)
3
Display the zebra pattern.
Press the [ZEBRA/5] button to display the zebra
pattern in the specified range.
.
During zebra pattern display, (zebra icon)
is displayed on the display screen in Camera
mode.
Memo :
0
“Zebra” is assigned to the [ZEBRA/5]
button in
factory default.
0
“Zebra” can also be assigned to other user
buttons.
(A P39
[Assignment of Functions to User
Buttons] )
Viewing Recorded Videos
Immediately (Clip
Review)
You can check (review) the last recorded video clip
on the screen.
However, the video clip cannot be played back if
the settings of the camera recorder are different
from the video format (Resolution/Frame Rate/Bit
Rate/SD Aspect) of the clip.
(A P118 [ W Resolution ] )
(A P118 [ W Frame Rate ] )
(A P118 [ W Bit Rate ] )
(A P119 [ SD Aspect ] )
Memo :
0
To use
this function, assign “Clip Review” to any
of the user buttons. “Clip Review” is assigned to
the [C.REVIEW/4] button in factory default.
0
“Clip
Review
” can also be assigned to other user
buttons.
(A P39 [Assignment of Functions to User
Buttons] )
.
1
Press the user button assigned with the
“Clip Review
”
function during standby
(“STBY” is displayed).
Playback of the configured section starts.
Memo :
0
The video clip is played back according to the
setting in [Main Menu] B [Camera Function] B
[User Switch Set]
B [Clip Review]. By default
setting (Last 5sec), the last 5 seconds of the clip
is played back.
(A P100
[ Clip Review ] )
0
When playback is complete, the camera
recorder exits Clip Review and returns to
“STBY” (recording standby) mode.
Setting Zebra Pattern
73
Shooting