INSTRUCTIONS

CH1 Filter to CH4 Filter
For setting the input signals for [CH-1] to [CH-4]
respectively to Wind Cut, Equalizer, or Off.
[Setting Values: Equalizer, Wind Cut, ROff]
Memo :
0
If the [AUDIO INPUT] signal selection switch 1
setting of [CH-1] in the [CH1 Filter] item is set to
“LINE”, “-” is displayed and selection is disabled.
0
When [CH2 Filter] is set as follows,
“-” is
displayed and selection is disabled.
0
When [CH-2] is set to “INPUT1
”, and the
[AUDIO INPUT] signal selection switch 1
setting is set to “LINE”
0
When [CH-2] is set to “INPUT2
”, and the
[AUDIO INPUT] signal selection switch 2
setting is set to “LINE”
0
If the [
AUDIO INPUT
] signal selection switch 1
setting of [CH-3] in the [CH3 Filter] item is set to
“LINE”, “-” is displayed and selection is disabled.
0
When [CH4 Filter] is set as follows,
“-” is
displayed and selection is disabled.
0
When [CH-4
] is set to “INPUT1”, and the
[AUDIO INPUT] signal selection switch 1
setting is set to “LINE”
0
When [CH-4] is set to
“INPUT2”, and the
[AUDIO INPUT] signal selection switch 2
setting is set to “LINE”
Equalizer
You can
correct the characteristic and enhance the
sound of the connected microphone using this
equalizer setting.
For setting the audio frequency from a 5-band
equalizer.
0
Frequency:
100Hz, 330Hz, 1kHz, 3.3kHz, 10kHz
0
Variable level:
± 6dB (0.5dB step)
Memo :
0
Audio will be recorded in the characteristic set
in the equalizer.
0
Set all bands to “0dB” to bypass the equalizer.
0
When the
equalizer level is set to the + side, the
audio may be distorted. In this case, reduce the
recording level in Manual mode.
0
If the values of multiple frequencies are
changed, the specified levels and the actual
levels may be different due to interference
between the frequency bands.
0
Not selectable if none of the items from [CH1
Filter] to [CH4 Filter] is set to “Equalizer”.
Output CH
For setting the channel to output to the [AUDIO
OUTPUT
] and [HDMI] terminals.
0
CH3/4:
Outputs the audio of [CH-3] and [CH-4
]
.
0
CH1/2:
Outputs the audio of [CH-1] and [CH-2].
0
SW Set:
Outputs according to the
[MONITOR SELECT]
switch setting.
[Setting Values: CH3/4, R
CH1/2, SW Set]
Monitor
For setting the audio sound of the [PHONES]
terminal to stereo or mixed sound when the
[MONITOR]
selection switch at the handle section
is set to “BOTH”.
0
Mix:
Outputs
mixed
sound (mixed sound of CH-1 and
CH-2) to both L and R.
0
Stereo:
Outputs stereo sound (outputs audio sound of
CH-1 to L, and CH-2 to R).
[Setting Values: RMix, Stereo]
Alarm Level
For selecting whether to turn on the warning tone
as well as setting the volume.
The warning tone is output from the monitor
speaker or [
PHONES] terminal.
[Setting Values: Off, 1 to 5] (R 5)
Test Tone
For specifying whether to output the audio test
signals (1 kHz) during color bar output.
[Setting Values: On, ROff]
A/V Set Menu
129
Menu Display and Detailed Settings