User manual

Charging the Battery
A battery is built into the camcorder.
.
CHARGE POWER/ACCE
S
To AC Outlet
(100 V to 240 V)
To DC/USB Device
Jack (Type-C)
AC Adapter(Provided)
Blinks: See below
Goes out: Charging
completed
Lights up: Charging in
progress
Charging Lamp
Power Cord (Provided)
CAUTION
0
The built-in battery is not charged at the time of purchase.
0
At the time of purchase or in case of the battery is not used for a long period
of time, the charging time will be longer than usual.
0
Charging time: Approx. 5 h (when charging at 25°C (77°F))
0
The battery cannot be charged outside the room temperature range of 10°C
to
35°C
(50°F to 95°F). The CHARGE lamp will blink slowly when the battery
is not being charged. If the temperature increases or decreases during
charging, the CHARGE lamp will blink slowly and charging will stop. In this
case, wait until the room temperature is within the above stated range before
charging again.
0
By using the supplied AC adapter, you can also charge the battery during
recording and video playback. (However, the charging time will be longer than
usual or the battery may not be charged.) If the internal temperature rises when
using the unit, stop the charging temporarily. (The CHARGE lamp will blink
slowly.)
0
If malfunctions (such as overvoltage) occur, charging will stop. In this case,
the CHARGE lamp blinks quickly as a notification.
0
If the recording time becomes extremely short even when the battery is fully
charged, the battery is worn out. The failure of built-in battery due to storage
and usage environment, and performance degradation resulting from battery
consumption due to use are not covered by the warranty and will be
chargeable even during the warranty period. Please consult your nearest JVC
dealer or JVC service center.
0
For details on other charging methods, please refer to the “Detailed User Guide”.
10 EN